Engineering Data Guide

88 Accessories
Mechanical accessories 6RWU0-02A
PTAC
2) Prepare the stamped Aluminum Grille for installation on the sleeve by inserting the six plastic grommets into the square
holes located near the outer edges of all the four sides of the Grille. Now with the Grille positioned so that the flanges of
all the four sides are in the up position (at 90 degrees), insert the grommets in the opposite direction so that their square
end protrudes through the grille through the flanges. The Grille is installed in such a way that it could be removed through
the rear sleeve opening.
3) Install the stamped Aluminum Grille by aligning the guide
pins located in the lower right and left hand corners of the
Grille with the corresponding holes in the rear of the wall
sleeve.
4) Secure the Grille by threading each of the screws into the
plastic grommets.
5) Remove the wire handle from the center of the grille prior
to installing the chassis into the sleeve.
(b) Architecture Grille.
1) Remove the cardboard stiffener and rear enclosure panel
from the sleeve. These items may be removed from the
inside of the room.
2) The Grille is installed in such a way that it could be
removed through the rear end of the sleeve.
3) Install the Grille by aligning the four screws supplied to
their corresponding holes in the architecture grille.
4) Secure the Grille to the sleeve by tightening the four
screws to their corresponding holes in the Grille.
5) Remove the wire handle from the center of the grille prior
to installing the chassis into the sleeve.