Engineering Data Guide

Accessories 97
Mechanical accessories6RWU0-02A
PTAC
3) Install the appropriate male-connector header onto the match-
ing on-board female connector.
4) Connect the kit wiring to the field wiring using the wire nuts
(included). Route the kit wiring as shown in the figure below.
Do not run the wires through basepan or wall sleeve.
2.8 Replacement Filter ( 10 Pack )
The unit is provided with two easy-to-use replaceable mesh
filters which can be cleaned periodically form time to time.
2.9 Wall Sleeve
These Wall Sleeve comes in industry standard size of
42" x 16"
These Wall Sleeves are fitted firmly onto the wall. The Air
Conditioner unit is slid onto it and held firmly to position by
this Wall Sleeve which acts as its support. Installation of a
wall sleeve allows flexibility to the PTAC unit.
Installation Procedure:
The Installation and servicing of the equipment should be
performed by qualified and experienced personnel only.
1) For installing the Wall Sleeve, a wall opening 42 x 16 –
1/4 x 13 – 3/4 inch required.
For Details please refer to the Design and Installation part for
installation of the Wall Sleeve.
Replacement Filter 10-Pack
AYFT110
42" Wall Sleeve
AYSVB01A