Engineering Data Guide

2 Mechanical Accessories
82 Accessories
Mechanical accessories 6RWU0-02A
PTAC
2.1 Control Panel Key Lock
Installation Procedure:
The Installation and servicing of the equipment should be per-
formed by qualified and experienced personnel only.
1) Remove the Front Grille from the unit by pulling at the bot-
tom on both sides and then lifting upwards as shown in the
figure on the right.
2) Remove the existing cover assembly by lifting the cover
halfway, using both hands and then slightly pull the cover
hinge pins so that these pins slide out of the mating holes.
3) After removing the existing cover assembly, install the cover
assembly with the key lock by applying slight pressure with
both hands so that the cover hinge pins align properly onto
the bracket.
The Control Panel Key Lock Kit prevents tampering
of the controls which is used to set temperatures and
other Heating and Cooling functions.
Control Panel Key Lock
AYCP101
Door
Front
Hinge Pins
(Each Side)
Brackets
(Each Side)