Owner's Manual

14
4 Maintenance
Shipping
Shipping
the Unit
the Unit
The original shipping carton and packing materi-
als can come in handy. For maximum protection,
re-pack the unit as it was originally packed at the
factory if you need to ship it.
Cleaning
Cleaning
the Unit
the Unit
Use a soft, dry cloth when cleaning the player. If
the surfaces are extremely dirty, use a soft cloth
lightly moistened with a mild detergent solution.
Never use strong solvents, such as alcohol, ben-
zine, or paint thinner. These might damage the
surface of the unit.
Do not use volatile liquids, such as insecticide
spray, near the unit. Do not leave rubber or plas-
tic products in contact with the unit for a long
period of time. They will leave marks on the sur-
face.
T
T
roubleshooting
roubleshooting
Symptom
No power.
No sound.
The unit does not
start playback.
The remote
control does not
work properly.
Cause
• The power cord is disconnected.
• The power of the external source
equipment is switched off.
• No disc or tape is inserted.
• An unplayable disc or tape is inserted.
• The disc is placed upside down.
• The disc is not placed within the guide.
• The disc is dirty.
• The remote control is not pointed at the
remote sensor of the unit.
• The remote control is too far from the
unit.
• There is an obstacle in the path of the
remote control and the unit.
• The batteries in the remote
control are exhausted.
Correction
• Plug the power cord into the wall
outlet securely.
• Switch on the external source
equipment.
• Insert a disc or tape.
• Insert a playable disc or tape.
• Place the disc with the playback side
down.
• Place the disc on the disc tray
correctly inside the guide.
• Clean the disc.
• Point the remote control at the
remote sensor of the unit.
• Operate the remote control
within about 23 ft (7 m).
• Remove the obstacle.
• Replace the batteries with new ones.