Website: http://us.lge.com Installation Manual Electric Range LRE30955S / LRE30855S LRE30755S / LRE30451S LRE30757S / LRE30453S Please read these instructions thoroughly before installing and operating the range. P/No.
Part 1 SAFETY 1 BEFORE YOU BEGIN Remove all tape and packing materials before using the range. Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. IMPORTANT SAFETY INSTRUCTIONS Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury, or damage when using the range. This guide does not cover all possible conditions that may occur.
Part 1 SAFETY PREPARE TO INSTALL THE RANGE WARNING TOOLS NEEDED • The information in this manual should be followed exactly. - A fire or electrical shock may result causing property damage, perasonal injury or death. WARNING • DO NOT step or sit on oven door. Install the Anti-Tip Bracket supplied with the range. - The range could be tipped and injury might result from spilled hot liquid, food, or the range itself.
Part 2 PREPARE TO INSTALL THE RANGE 2 INSTALLATION DRAWINGS NOTE SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. CLEARANCES AND DIMENSIONS (Figure 1) To install range refer to the following Figure 1. For installation in CANADA, a Free-standing range is not to be installed closer than 15/32 (12mm) from any adjacent surface. CAUTION CAUTION • Make sure that the wall covering, countertop and cabinets around the range can withstand the heat (up to 194°F) generated by the range.
Part 3 ELECTRICAL CONNECTIONS 3 ELECTRICAL CONNECTION 4 CONNECT RANGE CORD REQUIREMENTS The Rear Access cover must be removed. Loosen the three screws with a screwdriver. The terminal block will then be accessible. This appliance must be installed and grounded on a branch circuit by a qualified technician in accordance with the National Electrical code ANSI/NFPA NO. 70 latest edition. All wiring should conform to Local and NEC. This range requires a single-phase, 3 wire, A.
Part 3 ELECTRICAL CONNECTIONS 3-wire connection with a power supply cord WARNING • The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main terminal block. The remaining two wires of the power cord or conduit have to be connected to the outside posts of the main terminal connection block. - Failure to do so can result in electrical shock, severe personal injury or death.
Part 3 ELECTRICAL CONNECTIONS 4-wire connection with a power supply cord 3-wire connection: conduit Install the conduit as follows: WARNING Remove the Conduit connection plate from the rear of drawer body and rotate it as shown in Figure 5. The conduit hole (11/8”) must be used. • Only a 4-conductor power-supply cord kit rated 120/240 volts, 50 amperes and marked for use with ranges with closedloop connectors or open-end spade lugs with upturned ends shall be used.
Part 3 ELECTRICAL CONNECTIONS 4-wire connection: conduit 1. Follow the instructions under “Install the conduit as follows” on page 7 to correctly install the strain relief. DO NOT install the conduit without a strain relief. 2. Loosen the 2 lower left and right screws from the terminal block. (Refer to Figure 12.) Remove the lower 2 center screws. 3. Remove ground strap and discard as shown in Figure 12. Do not discard any screws. 4.
Part 4 INSTALL THE RANGE Replace the access cover on the range back. To replace the wire cover, insert double projections in the pockets located below the opening and tighten the three screws. Use a spirit level to check your adjustments. Place the level diagonally on the oven rack, and check each direction for level. 5 ANTI-TIP DEVICE INSTALLATION First check direction WARNING After check direction • DO NOT step or sit on oven door. Install the Anti-Tip Bracket supplied with the range. 1 2 . .
