ENGLISH ESPAÑOL INSTALLATION MANUAL ELECTRIC RANGE Please read these instructions thoroughly before installing and operating the range. LRE30955S LRE30755S LRE30757S LSE3094S LSE3092S LSRE307ST LRE30855S LRE30451S LRE30453S LRE3091S LSES302ST LSE3392S www.lg.
TABLE OF CONTENTS TABLE OF CONTENTS 3 SAFETY 3 Before You Begin 3 Important Safety Instructions 5 Prepare to Install the Range 6 PREPARE TO INSTALL RANGE 6 Installation Drawings (LRE/LSRE Series only) 7 Installation Drawings (LSE Series only) 8 ELECTRICAL CONNECTIONS 8 Electrical Connection Requirements 8 Connect Range Cord 9 3-Wire Connection With a Power Supply Cord 10 4-Wire Connection With a Power Supply Cord 10 3-Wire Connection: Conduit 11 4-Wire Connection: Conduit 12
SAFETY 3 Remove all tape and packing materials before using the range. Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. You can download the installation and owner’s manual at: http://www.lg.com. IMPORTANT SAFETY INSTRUCTIONS Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury, or damage when using the range. This guide does not cover all possible conditions that may occur.
SAFETY WARNING • Only a 4-conductor power-supply cord kit rated 120/240 volts, 50 amperes and marked for use with ranges with closed-loop connectors or open-end spade lugs with upturned ends shall be used. The middle (neutral) wire of the power cord or 4-wire conduit has to be connected to the middle post of the main terminal block. The other two wires of the power cord or conduit have to be connected to the outside posts of the main terminal connection block.
SAFETY 5 WARNING Tip - Over Hazard A child or adult can tip the range and be killed. Verify the anti-tip bracket have been installed. Ensure the anti-tip bracket is enganged when the range is moved. Do not operate the range without the antitip bracket in place. Failure to follow these instructions can result in death or serious burns to children and adults. To check visually that leveling leg is inserted into bracket, grasp the top rear edge of the range and carefully attempt to tilt it forward.
PREPARE TO INSTALL THE RANGE INSTALLATION DRAWINGS (LRE/LSRE Series only) NOTE SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. CLEARANCES AND DIMENSIONS (Figure 1) To install range refer to the following Figure 1. For installation in CANADA, a Free-standing range is not to be installed closer than adjacent surface. CAUTION 15/32 (12mm) from any CAUTION • M ake sure that the wall covering, countertop and cabinets around the range can withstand the heat (up to 194°F) generated by the range.
PREPARE TO INSTALL THE RANGE 7 ENGLISH INSTALLATION DRAWINGS (LSE Series only) NOTE SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR CLEARANCES AND DIMENSIONS (Figure 1) To install range refer to the following Figure 1. For installation in CANADA, a Free-standing range is not to be installed closer than adjacent surface. CAUTION 15/32 (12mm) from any CAUTION • M ake sure that the wall covering, countertop and cabinets around the range can withstand the heat (up to 194°F) generated by the range.
ELECTRICAL CONNECTIONS ELECTRICAL CONNECTION REQUIREMENTS This appliance must be installed and grounded on a branch circuit by a qualified technician in accordance with the National Electrical code ANSI/NFPA NO. 70 latest edition. All wiring should conform to Local and NEC. This range requires a single-phase, 3 wire, A.C 120/208V or 120/240V 60Hz electrical system.
ELECTRICAL CONNECTIONS 9 ENGLISH 3-WIRE CONNECTION WITH A POWER SUPPLY CORD WARNING •T he middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main terminal block. The remaining two wires of the power cord or conduit have to be connected to the outside posts of the main terminal connection block. - Failure to do so can result in electrical shock, severe personal injury or death.
ELECTRICAL CONNECTIONS 4-WIRE CONNECTION WITH A POWER SUPPLY CORD WARNING • O nly a 4-conductor power-supply cord kit rated 120/240 volts, 50 amperes and marked for use with ranges with closedloop connectors or open-end spade lugs with upturned ends shall be used. The middle (neutral) wire of the power cord or 4-wire conduit has to be connected to the middle post of the main terminal block.
ELECTRICAL CONNECTIONS 11 ENGLISH 4-WIRE CONNECTION: CONDUIT 1. Follow the instructions under “Install the conduit as follows” on page 10 to correctly install the strain relief. DO NOT install the conduit without a strain relief. 2. Loosen the 2 lower left and right screws from the terminal block. (Refer to Figure 12.) Remove the lower 2 center screws. 3. R emove ground strap and discard as shown in Figure 12. Do not discard any screws. 4.
INSTALL THE RANGE Replace the access cover on the range back. To replace the wire cover, insert double projections in the pockets located below the opening and tighten the three screws. Lower range Leg leveler Raise range Access cover Use a spirit level to check your adjustments. Place the level diagonally on the oven rack, and check each direction for level. ANTI-TIP DEVICE INSTALLATION WARNING Tip - Over Hazard A child or adult can tip the range and be killed.
