Installation Guide
17INSTALLATION
ENGLISH
3  Connect all the wire harnesses d and the 
ground screw e .
NOTE
• The number of wire harnesses may vary 
depending on the model.
• Ground wire is only available on some models.
Assembling the Left Refrigerator 
Door
CAUTION
• Install the left refrigerator door after the right 
door is installed.
1  Make sure that the plastic sleeve is inserted in 
the bottom of the door. Install the refrigerator 
door onto the middle hinge.
2  Fit the hinge a over the hinge lever latch b 
and slot it into place. Rotate the lever c 
clockwise and fasten the hinge.
3  Connect all the wire harnesses and the 
ground wire.
4  Push the water supply lines into the hole on 
the top case and pull them through the 
backplate.
5  Hold the water supply connection and gently 
push in the collet 
d to connect the water 
supply lines as shown. Insert the tube at least 
5/8 inch (15 mm) into the connector. Insert 
the clip on the joint to fasten the tubes in 
place.
NOTE
• Disassembling/Assembling the Water Lines
e Collet f Tube g Insert line h Clip
us_main.book.book Page 17 Friday, February 7, 2020 11:44 AM










