Owner's Manual

17INSTALLATION
ENGLISH
3 Connect all the wire harnesses d and the
ground screw e .
NOTE
The number of wire harnesses may vary
depending on the model.
Ground wire is only available on some models.
Assembling the Left Refrigerator
Door
CAUTION
Install the left refrigerator door after the right
door is installed.
1 Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator
door onto the middle hinge.
2 Fit the hinge a over the hinge lever latch b
and slot it into place. Rotate the lever c
clockwise and fasten the hinge.
3 Connect all the wire harnesses and the
ground wire.
4 Push the water supply lines into the hole on
the top case and pull them through the
backplate.
5 Hold the water supply connection and gently
push in the collet
d to connect the water
supply lines as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tubes in
place.
NOTE
Disassembling/Assembling the Water Lines
e Collet f Tube g Insert line h Clip
us_main.book.book Page 17 Friday, February 7, 2020 11:44 AM