Owner’s Manual

14 INSTALLATION
NOTE
• The number of wire harnesses may vary
depending on the model.
• Ground wire is only present on some models.
Assembling the Freezer Door
1 Install the freezer door onto the bottom hinge
pin
a.
2 Fit the hinge b over the hinge lever latch c
and slot it into place. Rotate the lever
d
clockwise and fasten the hinge.
NOTE
• Align the freezer door with the cabinet to help fit
the top hinge in place.
3 Connect all the wire harnesses and the
ground wire.
4 Push the water supply lines into the hole on
the top case and pull them through the
backplate.
NOTE
• The number of wire harnesses may vary
depending on the model.
• Ground wire is only present on some models.
5 Hold the water supply connection and gently
push in the collet e to connect the water
supply lines as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tubes in
place.
NOTE
• Disassembling/Assembling the Water Lines
f Collet g Tube h Insert line i Clip
en-us_main.book.book Page 14 Friday, February 10, 2023 11:43 AM