Use and Care Manual

ManualsBrandsLG ManualsRefrigeration36 Inch Side by Side Refrigerator with 27.2 Cu. Ft. Capacity, SpacePlus® Ice System, Smooth Touch Dispenser, Door Cooling+, Sabbath Mode, ADA Compliant, and ENERGY STAR® Qualified: White

22 OPERATION

OPERATION

Before Use

Checklist

Clean the refrigerator.

Clean the refrigerator thoroughly and wipe off all dust that accumulated

during shipping.

CAUTION

erator with a sharp object or use a detergent that

contains alcohol, a flammable liquid or an abrasive when removing any

tape or adhesive from the refrigerator. Remove adhesive residue by wiping

it off with your thumb or dish detergent.

al number label or the technical

information on the rear surface of the refrigerator.

Open doors and drawers to ventilate the interior.

The inside of the refrigerator may smell like plastic at first. Remove any

adhesive tape from inside the refrigerator and open the refrigerator doors

and drawers for ventilation.

Connect the power supply.

Check if the power supply is connected before use.

Turn off the icemaker.

Turn off the icemaker if the refrigerator is not yet connected to the water

supply.

NOTE

refrigerator is not connected to the water supply.

Wait for the refrigerator to cool.

Allow the refrigerator to run for at least two to three hours before putting

food in it. Check the flow of cold air in the freezer compartment to ensure

proper cooling.

CAUTION

spoil, or a bad odor to remain inside the refrigerator.

The refrigerator makes a loud noise after initial operation.

This is normal. The volume will decrease as the temperature decreases.

Summary of content (11 pages)

PAGE 1
22 OPERATION OPERATION Before Use Checklist Clean the refrigerator. Clean the refrigerator thoroughly and wipe off all dust that accumulated during shipping. CAUTION erator with a sharp object or use a detergent that contains alcohol, a flammable liquid or an abrasive when removing any tape or adhesive from the refrigerator. Remove adhesive residue by wiping it off with your thumb or dish detergent. al number label or the technical information on the rear surface of the refrigerator.
PAGE 2
OPERATION 23 Control Panel Depending on the model, some of the following functions may not be available. Control Panel Features Refrigerator Control Panel a Refrigerator Indicates the set temperature of the refrigerator compartment in Celsius (°C) or Fahrenheit (°F). The default refrigerator temperature is 37 °F (3 °C). Press the Refrigerator button repeatedly to select a new set temperature from 33 °F to 43 °F (1 °C to 7 °C).
PAGE 3
24 OPERATION b Water Filter Replace the water filter when the Replace Filter icon turns on. After replacing the water filter, press and hold the Water Filter button for three seconds to turn the icon light off. Replace the water filter approximately every six months. c Freezer Indicates the set temperature of the freezer compartment in Celsius (°C) or Fahrenheit (°F). The default freezer temperature is 0 °F (-18 °C).
PAGE 4
OPERATION 25 i Ice On/Off Press and hold the Ice On/Off button for three seconds to turn the in-door icemaker on/off. The lock function disables every other button on the display. Lock button until the indicator appears in the display and the function is activated. Lock button for approximately three seconds. NOTE Display Mode (For Store Use Only) - The Display Mode disables all cooling in the refrigerator and freezer sections to conserve energy while on display in a retail store.
PAGE 5
26 OPERATION Ice and Water Dispenser Before Using the Ice and Water Dispenser CAUTION close to the dispenser as possible to avoid spilling. Using the Ice and Water Dispenser 1 Press the icon for the desired dispenser mode a. The LED over the selected icon turns on. 2 Press the dispenser paddle b with a glass or other container to dispense cubed ice, water or crushed ice. may play with or damage the controls. 160 cubes) after installation.
PAGE 6
OPERATION 27 Cleaning the Dispenser Tray the passage with a rubber spatula. Dispensing cubed ice can also help prevent frost buildup. Detaching/Assembling the In-Door Ice Bin CAUTION Electronics service center should disassemble or repair the icemaker. from the icemaker tray area to avoid personal injury. Locking the Ice and Water Dispenser shutoff (feeler arm) when replacing the ice bin. Press and hold the Lock button for three seconds to lock the dispenser and all the control panel functions.
PAGE 7
28 OPERATION a Auto Shutoff (feeler arm) Before Using the Freezer Icemaker This feature is only available on some models. The feature may vary depending on model purchased. NOTE installation. This is also necessary if the refrigerator has not been used for a long time. Automatic Icemaker WARNING when the refrigerator is plugged in. y moving parts of the ejector mechanism or with the heater that releases the ice cubes. Before Using the In-Door Icemaker NOTE and sent to the dispenser.
PAGE 8
OPERATION 29 on or water filter replacement, the first few batches of ice may be semicircular or contain air bubbles. depending on the water quality in the installation location and the operating conditions. ice bin, as they may stick to the ice stored in the ice bin. r outage, it will take longer to make the first batch of ice, and the ice may not be round. If the power will be out for a longer period, throw away the ice stored in the ice bin.
PAGE 9
30 OPERATION How to Store Food - Keep opened butter in covered dish or closed compartment. When storing an extra supply, wrap in freezer packaging and freeze. - Store in original wrapping until used. Once opened, rewrap tightly in plastic wrap or aluminum foil. condensation to form. Wipe off the condensation with a clean cloth or a paper towel. Storing Frozen Food Check a freezer guide or a reliable cookbook for further information about preparing food for freezing or food storage times.
PAGE 10
OPERATION 31 b Water tank (Type B) Removing/Assembling Drawers 1 To remove drawers, pull them out to full extension, lift the front, and pull straight out. Refrigerator Shelves The shelves in the refrigerator are adjustable to meet individual storage needs. Adjusting the shelves to fit items of different heights will make finding the exact item you want easier. Detaching/Assembling Shelves CAUTION while they are cold. Shelves may break if exposed to sudden temperature changes or impact.
PAGE 11
32 OPERATION InstaView Door-in-Door 1 To remove the bin, simply lift the bin up and pull straight out. 2 To assemble the bin, slide it in above the desired support and push down until it snaps into place. Knock twice on the glass to turn the LED light inside the InstaView on or off. The LED light turns off automatically after 10 seconds. CAUTION NOTE open. InstaView function will not activate for two seconds after closing the door. InstaView function is disabled when the ice dispenser is in use.