Room Air Conditioner 室內冷董童 ENGLISH OWNER'S MANUAL 使用手冊 ? Please read before ? carefully and thoroughly operating this unit. Contact the authorized SVC man for this manual repair or maintenance of this unit. ? Contact the installer for installation of this unit. ? The is not intended for use by young infirm persons without supervision. children should be supervised to ensure that appliance children ? Young they do or not play with the appliance.
Safety precautions Safety Precautions Warning ................................2 To Caution .................................3 Incorrect operation damage, symbols. the seriousness of which is indicated due to ignoring instructions will cause the by harm or following Instructions Operating Preparation prevent injury and property damage, follow these instructions. before operation ..4 This symbol shows the This symbol indicates the possibility of death serious or injury.
Ventilate before operating air conditioner Do not disassemble when gas goes out. ? It may cause fire explosion, Never touch the metal of the unit when or modify products randomly. and, burn. parts removing ? It may cause ENGLISH failure and electric shock. Do not clean the air Ventilate well when used conditioner with water. together with a stove, etc. the filter. ? They are sharp injury. When and may cause ? Water may enter the unit and degrade the insulation.
Preparation before operation How to Insert the Batteries Remove the battery arrow direction. Insert new battery are batteries installed Reattach the cover cover by pulling making sure correctly. by sliding it according that the it back into (+) to the and (-) of position. NOTES: ? Use 2 AAA(1.5volt) batteries. Do not use rechargeable batteries. Storage and Tips For Using ? The remote control may be stored a wall.
Signal Receptor Each Icon turns on when the unit is operated, then the only Icon outline to be operated is bright.
About the remote control The remote control transmits the signals to the on the system system. Features of the Remote Control- Door 1 Opened START/STOP BUTTON Operation starts when this button is pressed and stops when the button is pressed again. 2 OPERATION MODE SELECTION BUTTON Used to select the operation mode. 3 ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature. 4 5 INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS.
How to use the Operation Mode Selection button Cooling Operation 1 Press the a 2 Start/Stop button. respond with The unit will Open the door on the remote control. To select Cooling Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the 3 Close the door lower than the set within 4 ENGLISH beep. a Set the fan on arrow. the remote control. Set the room temperature temperature.
Auto Operation 1 Press the a 2 Start/Stop button. respond with The unit will beep. Open the door on the remote control. To select Auto Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the 3 The arrow. temperature and fan speed electronic controls based on are automatically the actual room set by the temperature. If change the set temperature, press the Room Temperature Setting buttons.
Healthy Dehumidification Operation 1 Press the a 2 Start/Stop button. respond with ENGLISH The unit will beep. Open the door on the remote control. To select Dehumidification Operation, press the Healthy Operation Mode Selection button. Each time the button is pressed, shifted in the direction of the 3 Set the fan speed again operation mode is with the door of the remote control still closed.
Heating Operation(Heat pump 1 Press the Start/Stop button. respond with beep. Open the door on the remote control. To select Heating Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the 3 only) The unit will a 2 model Close the door on arrow. the remote control. Set the temperature higher than the room temperature. The temperature can be set within a range of 16°C~30°Cin 1°C increments.
Jet Cool Operation 1 Press the a 2 ENGLISH beep. Press the Jet Cool button to the will on 3 Start/Stop button. respond with The unit will speed cooling operate mode and the unit operate in super high fan speed cooling mode for 30 minutes. To cancel the Jet Cool mode, press the Jet Cool button or room temperature setting button again and the unit will operate in high fan speed on cooling the fan speed button or the mode.
PLASMA Purification 1 Operation(Optional) Press the Start/Stop button. respond with a The unit will beep. 2 3 Open the door on the remote control. Press the PLASMA air purifying operation ON/OFF button. Operation will start when the button is pressed and stop when the button is pressed again. Set the fan closed. You speed again with door of the remote control speed in four steps-low, medium, high or CHAOS. Each time the button is pressed, the fan speed mode is shifted.
2nd F Operation 1 Press the a 2 Start/Stop button. respond with ENGLISH The unit will beep. Open the door of the remote control and press the 2nd operate functions printed in blue at bottom Function button to of buttons. (Check the display.) indication of 2nd function These buttons 3 operate the timer setting 2nd function goes off in the button is on a short time remote control as follows: automatically or when pressed again. For more details, refer to functions next page.
Additional features Mode Sleep 1 Press the Sleep To cancel the Sleep Mode, press the sleep Mode Auto button several times until the star Mode Auto button to set the time you want the unit to turn off automatically. ( 2 programmed in one-hour by pressing the Sleep Mode increments The 14 the Sleep Mode will be operated at speed (cooling) or medium fan speed (heat pump only) for quiet sleeping.
Vertical Airflow Direction Control The up/down airflow (Vertical Airflow) adjusted by using the remote control. be can Note: If you press the CHAOS swing button, the horizontal airflow direction is changed automatically based on the CHAOS algorithm to distribute the air in the room evenly and at the same time to make the human body feel most comfortable, as if enjoying a natural breeze. 1 2 Press the Press Chaos Swing Always use the remote control to adjust the up/down airflow direction.
Auto Clean ? the door on the remote control. Press the Auto Clean Button. Close the door on the remote control. Now each time that you press the Open start/stop button, the Air conditioner operates clean function automatically. Display Luminosity ? The Display Luminosity can be adjusted by using the remote control. start/stop button to start the unit. Open the door on the remote control, press the 2ndF button and, press display luminosity button. Display will be dark.
Forced Operation Operation procedures when the remote control can't be used. The operation will pressed. ENGLISH be started if the power button is If you want to the button. stop operation, re-press Cooling Model Operating mode Indoor FAN Speed Setting Temperature Test Heat pump Model Room Temp. ≥ 24°C Cooling Cooling High High 21°C≤ Room Healthy Temp. < 24°C Dehumidification High Room Temp.
Care and maintenance of the air conditioner CAUTION: Before performing any maintenance, turn off the main power to the system. Indoor Unit 1 the Open upside of Front Panel Relocate dried air filters at the shade and then 5 close the 2 Put up the Front panel. The hook of panel comes off. Never use panel and then followings: Water hotter than 40°C ? Volatile substances Could Come down the any of the ? Could 3 panel. cause deformation and/or discoloration.
Cleaning ? of Purifying Filter Recomended 1 3 use period Open the upside panel. : About 3 months of Front Remove air filter and then 2 pull 4 plasma filter. (1 plasma filter) out Put up the front panel. The hook of panel comes off. Put in plasma filter in the detergent for 1~2 exchanger coils Remove air filter and then pull plasma filters. (2 plasma filters) out 5 Relocate dried ENGLISH plasma neutral filters at the shade and hours and then raise them.
When the air conditioner is not going to be used for a When air conditioner is not used for going to be When the air conditioner is to be used long time. a unit. (Refer to page This will dry 18 for cleaning filters.) out the internal mechanisms. Turn off the circuit the again. Clean the air filter and install it in the indoor Operate the air conditioner on Air circulation mode (Refer to page 15) for 2 to 3 hours. ? long time. breaker, and disconnect plug.
Before you call for service... Troubleshooting Tips! Save Check the following points contact your dealer or before The air conditioner does not operate. ? a peculiar service.... If the fault ? odor. persists, please See page Have you made a mistake in timer operation? Has the fuse blown or has the circuit breaker been has or Explanation ? room requesting repairs money! service center.
Memo 22
