Room Air Conditioner OWNER'S MANUAL ? Please read before ? carefully and thoroughly operating this unit. Contact the authorized SVC man for this manual repair or maintenance of this unit. ? Contact the installer for installation of this unit. ? The is not intended for use by young infirm persons without supervision. children should be supervised to ensure that appliance children ? Young they do Prior to or not play with the appliance.
Safety precautions Safety Precautions Warning ................................2 To Caution .................................3 Incorrect operation damage, symbols. the seriousness of which is indicated before operation due to ignoring instructions will cause the by harm or following WARNING WARNING Instructions Operating Preparation prevent injury and property damage, follow these instructions. ..4 This symbol shows the possibility of death serious or injury.
WARNING WARNING Ventilate before operating air conditioner Do not disassemble when gas goes out. ? It may cause or modify products randomly. fire explosion, and, burn. ? It may cause failure and electric shock. CAUTION CAUTION Never touch the metal of the unit when parts removing Do not clean the air Ventilate well when used conditioner with water. together with a stove, etc. the filter. ? They are sharp injury.
Preparation before operation How to Insert the Batteries Remove the battery arrow direction. Insert new battery are batteries installed Reattach the cover cover by pulling making sure correctly. by sliding it according that the it back into (+) to the and (-) of position. NOTES: TroubleshtingpCadMcOISfyP 4 ? Use 2 AAA(1.5volt) batteries. Do not use rechargeable batteries. Storage and Tips For Using ? The remote control may be stored a wall.
Signal Receptor Each Icon turns on when the unit is Cooling Auto operated, Mode Operation Mode Healthy Dehumidification Mode Heating Mode then the only Icon outline to be up during Cooling operation. (Outline) Lights up during Lights up during Healthy Auto Lights up during Mode Lights up during Sleep Timer Mode Lights up during Timer operation. (Outline) up during Defrost control or Hot Start in Heating operation.
About the remote control The remote control transmits the signals to the on the system system. Features of the Remote Control- Door 1 Signal TroubleshtingpCadMcOISfyP 6 OPERATION MODE SELECTION BUTTON Used to select the operation mode. 3 ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature.
How to use the Operation Mode Selection button Cooling Operation 1 Press the a 2 Start/Stop button. respond with The unit will beep. Open the door on the remote control. To select Cooling Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the Auto Cooling 3 Close the door lower than the set within a arrow. Healthy Dehumidification on Heating (Heat pump model only) the remote control.
Auto Operation Press the 1 a TroubleshtingpCadMcOISfyP 8 Start/Stop button. respond with The unit will 2 beep. Open the door on the remote control. To select Auto Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the Auto Cooling ON 3 The arrow.
Healthy Dehumidification Operation Press the 1 Start/Stop button. respond with The unit will a 2 beep. Open the door on the remote control. To select Dehumidification Operation, press the Healthy Operation Mode Selection button. Each time the button is pressed, shifted in the direction of the Auto Cooling 3 Set the fan operation Healthy Dehumidification speed again mode is Heating (Heat pump model only) with the door of the remote control still closed.
Heating Operation(Heat pump 1 Press the TroubleshtingpCadMcOISfyP 10 Start/Stop button. respond with beep. Open the door on the remote control. To select Heating Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the Close the door arrow. Auto Cooling 3 only) The unit will a 2 model Healthy Dehumidification on Heating (Heat pump model only) the remote control.
Jet Cool Operation 1 Press the a 2 beep. Press the Jet Cool button to the will on 3 Start/Stop button. respond with The unit will speed cooling operate mode and the unit operate in super high fan speed cooling mode for 30 minutes. To cancel the Jet Cool mode, press the Jet Cool button or room temperature setting button again and the unit will operate in high fan speed on cooling the fan speed button or the mode.
PLASMA Purification 1 Operation(Optional) Press the Start/Stop button. respond with a The unit will beep. TroubleshtingpCadMcOISfyP 12 2 3 Open the door on the remote control. Press the PLASMA air purifying operation ON/OFF button. Operation will start when the button is pressed and stop when the button is pressed again. Set the fan closed. You speed again with door of the remote control speed in four steps-low, medium, high or CHAOS.
2nd F Operation 1 Press the a 2 Start/Stop button. respond with The unit will beep. Open the door of the remote control and press the 2nd operate functions printed in blue at bottom Function button to of buttons. (Check the display.) indication of 2nd function These buttons on operate the timer setting remote control as follows: CANCEL ON OFF SET AUTO CLEAN CANCEL ON OFF SET AUTO CLEAN 3 2nd function goes off in the button is a short time automatically or when pressed again.
Additional features Mode Sleep 1 Press the Sleep To cancel the Sleep Mode, press the sleep Mode Auto button several times until the star Mode Auto button to set the time you want the unit to turn off automatically. ( 2 programmed in one-hour by pressing the Sleep Mode increments Auto The 14 the Sleep Mode will be operated at speed (cooling) or medium fan speed (heat pump only) for quiet sleeping.
Vertical Airflow Direction Control The up/down airflow (Vertical Airflow) adjusted by using the remote control. be can Note: If you press the CHAOS swing button, the horizontal airflow direction is changed automatically based on the CHAOS algorithm to distribute the air in the room evenly and at the same time to make the human body feel most comfortable, as if enjoying a natural breeze. 1 Press the Press Chaos 2 Swing Always use the remote control to adjust the up/down airflow direction.
Auto Clean ? the door on the remote control. Press the Auto Clean Button. Close the door on the remote control. Now each time that you press the Open start/stop button, the Air conditioner operates clean function automatically. TroubleshtingpCadMcOISfyP 16 Display Luminosity ? The Display Luminosity can be adjusted by using the remote control. start/stop button to start the unit. Open the door on the remote control, press the 2ndF button and, press display luminosity button.
Forced Operation Operation procedures when the remote control can't be used. The operation will pressed. be started if the power button is If you want to the button. stop operation, re-press Power button Cooling Model Operating mode Indoor FAN Speed Setting Temperature Test Heat pump Model Room Temp. ≥ 24°C2 1 °C ≤ Room Cooling Cooling High High Healthy Temp. < 24°C Dehumidification High Room Temp.
Care and maintenance of the air conditioner CAUTION: Before performing any maintenance, turn off the main power to the system. Indoor Unit 1 the Open upside of Front Panel Relocate dried air filters at the shade and then 5 close the panel. Air filters TroubleshtingpCadMcOISfyP 18 Front 2 panel Put up the Front panel. The hook of panel comes off. Never use any of the followings: ? Water hotter than 40°C ? Volatile substances Could Could cause deformation and/or discoloration.
Cleaning ? of Purifying Filter Recomended 1 use period Open the upside panel. : About 3 months of Front Put up the front panel. The hook of panel comes off. 2 3 Remove air filters and then pull out plasma filter Plasma filters Front 4 panel Put in Panel hook plasma filters in the detergent for 1~2 5 Relocate dried filters plasma neutral at the shade and then hours and then raise them. air filters.
When the air conditioner is not going to be used for a When air conditioner is not used for going to be When the air conditioner is to be used long time. a unit. (Refer to page TroubleshtingpCadMcOISfyP 20 This will dry 18 for cleaning filters.) out the internal mechanisms. Turn off the circuit the again. Clean the air filter and install it in the indoor Operate the air conditioner on Air circulation mode (Refer to page 15) for 2 to 3 hours. ? long time. breaker, and disconnect plug.
Before you call for service... Troubleshooting Tips! Save ? Check the following points contact your dealer or before The air conditioner does not operate. ? a peculiar service.... If the fault ? odor. persists, please See page Have you made a mistake in timer operation? Has the fuse blown or has the circuit breaker been has or Explanation ? room requesting repairs money! service center.
Memo 22
P/No.: 3828A20243Y After reading this manual, Printed in Korea keep it in a place easily accessible to the user for future reference.