LG LG Room Air Conditioner OWNER'S MANUAL Prior to installation, this air-conditioning unit must be submitted for approval by the utility service which provides electricity (EN 61000-2, EN 61000-3 Norm). IMPORTANT ? ? Please read this owner's manual and before air conditioner. installing and carefully operating your room thoroughly Please retain this owner's manual for future reference after reading it thoroughly. P/No.
Room Air Conditioner Owner's Manual TABLE OF CONTENTS FOR YOUR RECORDS Write the model and serial numbers here: Model # Serial # You can find them on a label on the side of each unit. Dealer's Name Date Purchased Staple your receipt to this purchase to prove date of Safety Precautions .................3 Prior to ..................6 Operation Operating Instructions...........7 Remote Controller ..............7 Remote Control Operation.8 Additional features...............
Safety Precautions Safety To to the prevent injury Precautions user or other people and property damage, the following instructions must be followed. Incorrect classified operation due to ignoring instruction by the following indications. WARNING This symbol CAUTION This symbol Meanings of symbols will indicates the indicates the used in this manual Be sure possibility or The seriousness is damage. of death or serious injury.
Safety Precautions Operation ? Do not operate pulling out the power It will cause or stop the unit by inserting plug. electric shock or fire due to heat Do not allow water to or ? It may cause run into electric failure of machine or parts. electric shock. generation. Do not operate with wet hands or in Do not direct airflow at damp room occupants only. environment.
Safety Precautions Operation Never touch the metal removing ? They sharp are parts of the unit when and may cause Ventilate well when used stove, ? Do not clean the air conditioner with water. the filter. injury. ? together with When a cleaning the unit, first breaker etc. An oxygen Water may enter the unit and may cause an electric shock. shortage may ? occur. it will be cause Do not as make sure insulation. It the power and turned off.
Prior to operation Prior to operation Preparing for operation 1. Contact 2. in the power Plug 3. Use installation an specialist for installation. plug properly. dedicated circuit. a 4. Do not use an 5. Do not start/stop operation by plugging/unplugging 6. If the extension cord. cord/plug is damaged, replace it with only an the power cord. authorized replacement part. Usage 1. Being exposed to direct airflow for an Do not expose occupants, pets, plants 2.
Operating Instructions Instructions Operating Remote Controller Remove the the Insert of battery cover by pulling new batteries battery are Reattach the NOTICE Do not to according making sure that the (+) correctly. and (-) installed cover by sliding it back into position. Use 2 AAA(1.5volt) batteries. rechargeable batteries. : use Storage ? it direction. arrow and Tips For Using the Remote Control The remote control may be stored wall.
Operating Instructions Remote Control The remote control transmits the Operation signals to the system. 1 Signal transmitter 5 1 6 3 23 10 72 ON 11 AUTO CLEAN 8 17 13 18 15 14 ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature. INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS. 5 JET COOL Used to start 6 CHAOS SWING BUTTON Used to stop or start louver movement and set the desired up/down airflow direction.
Operating Instructions Cooling Operation 1 2 Press the Start/Stop button. respond with The unit will a beep. Open the door on the remote control. To select Cooling Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the Auto Cooling 3 on lower than the room a Set the fan Heating (Heat pump model only) the remote control. Set the temperature temperature.
Instructions Operating Auto Operation(Optional) Press the Start/Stop button. respond with 1 The unit will 2 Open the door on the remote control. To select Auto Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is a beep. shifted in the direction of the Auto Cooling 3 ON The arrow.
Operating Auto pump model Changeover Operation(Heat Press the Instructions only) Start/Stop button. respond with 1 The unit will 2 Open the door on the remote control. To select Auto Changeover Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the a beep. direction of the arrow.
Operating Instructions Healthy Dehumidification 1 2 Operation Press the Start/Stop button. respond with The unit will a beep. Open the door on the remote control. To select Dehumidification Operation, Each time the button is pressed, Set the fan the operation Healthy Dehumidification speed again mode is arrow. Auto Cooling Heating (Heat pump model only) with the door of the remote control still closed.
Operating Heating Operation(Heat pump Press the model Instructions only) Start/Stop button. respond with 1 The unit will 2 Open the door on the remote control. To select Heating Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is a beep. shifted in the direction of the Auto Cooling 3 Close the door arrow. Healthy Dehumidification on Heating (Heat pump model only) the remote control.
Operating Instructions Jet Cool Operation Press the Start/Stop button. respond with 1 The unit will 2 the a beep. Press the Jet Cool button to will on 3 speed cooling operate mode and the unit operate in super high fan speed cooling mode for 30 minutes. To cancel the Jet Cool mode, press the Jet Cool button or room temperature setting button again and the unit will operate in high fan speed on cooling the fan speed button or the mode.
Operating PLASMA Purification 1 2 3 Instructions Operation(Optional) Press the Start/Stop button. respond with a The unit will beep. Open the door on the remote control. Press the PLASMA air purifying operation ON/OFF button. Operation will start when the button is pressed and stop when the button is pressed again. Set the fan speed again closed. You with door of the remote control speed in four steps-low, medium, high or CHAOS.
Operating Instructions Oxygen-generator Operation(Optional) 1 2 Press the Start/Stop button. respond with a The unit will beep. Open the door Press the on the remote control. Oxygen-generator operation ON/OFF button. Operation will start when the button is pressed and stop when pressed again. 3 Set the fan speed again closed. You the button is with door of the remote control speed in four steps-low, medium, high or CHAOS.
Operating 2nd F Instructions Operation 1 2 Press the Start/Stop button. respond with The unit will a beep. Open the door of the remote control and press the 2nd operate functions printed in blue at bottom Function button to of buttons. (Check the display.
Operating Instructions Additional features Sleep 1 Press the Mode To cancel the Sleep Mode, press the sleep Mode Auto button several times until the star Mode Auto button to set the Sleep time you want the unit to turn off automatically. ( 2 programmed in one-hour by pressing the Sleep Mode ) disappears from the operation display. The Timer is increments Auto NOTICE The Sleep Mode will be operated at slow fan speed (cooling) or medium fan speed (heat pump only) for quiet sleeping.
Operating Instructions Vertical Airflow Direction Control The up/down airflow (Vertical Airflow) adjusted by using the remote control. can be NOTICE If you press the CHAOS swing button, the horizontal airflow direction is changed automatically based on the CHAOS Press the Start/Stop Always up/down as use button to start the unit. time to make the human same comfortable, 1 to distribute the air in the algorithm and at the if enjoying Swing button and the louvers will natural breeze.
Operating Instructions Air Circulation Mode Circulates the 1 2 Press the Open room air without Start/Stop the door on cooling or button. the unit will heating. respond with beep. a the remote control. Press the Air Circulation button. Close the door remote control. Now each time that you press the Indoor Fan shifted from low to CHAOS and back to low again. CHAOS Air Fan speed is on low. Fan Speed Selector, speed is on medium.
Maintenance and Service Maintenance and Service CAUTION: Before performing any maintenance, turn off the main power to the system. Indoor Unit Never Grille, Case, and Remote Control Turn the off before system cleaning. clean, wipe with a soft, dry cloth. Do use bleach or ? To Could not before followings: cause deformation and/or Volatile substances Could Supply power must be disconnected cleaning any of the discoloration. abrasives.
Maintenance and Service Replacement of Purifying Filter(Optional) ? Recomended 1 Open use front period panel : About 2 years and remove air 2 Remove 3 Insert Triple Deodorizing filter. filters. new Triple Deodorizing filter. Air filter 2 3 4 Reinsert air filters and close front panel. Triple Deodorizing Filter Outdoor Unit The heat outdoor unit should be checked exchanger coils and panel vents of the regularly.
Maintenance and Service Oxygen Generator Unit The air filter in the oxygen (Optional) generator should be checked and cleaned once in a year or more if necessary. NOTE: Dirty or clogged air filter will reduce Air intake vents (Side) Air outlet vent Open 1234 56 oxygen concentration. the top cover. Take out the filter Open assembly. it and Remove the filter.
Maintenance and Service When the air conditioner is not going to be used for a When air conditioner is not used for long a to be going When the air conditioner is to be used time. Operate the air conditioner on unit. (Refer to This will dry page 21 for cleaning filters.) out the internal mechanisms. Turn off the circuit the again. Clean the air filter and install it in the indoor mode for 2 to 3 hours. ? long time. breaker, and disconnect plug.
Maintenance and Service Troubleshooting Check the following points before requesting repairs or service.... If the fault persists, please contact your dealer or service center. Case The air conditioner does not operate. ? Have you made a mistake in timer operation? Has the fuse blown or has the circuit breaker been The room has a See page Explanation ? peculiar ? odor.
Maintenance and Service Details of LG serial No. 1234567891 0 Code Detail 1 Year Code of Model Meaning The last 0~9 (Digit) Month 2,3 Month (Digit) ex) A~Z Product of year 7, 2000 March 0 03, August 08 Where manufactured (Alphabet) 5 digit 1997 01~12 Nation 4 ex) A~Z ex) K Korea, C China ex) A Airconditioner (Alphabet) Serial No.
