LG LG Room Air Conditioner OWNER'S MANUAL Prior to installation, this air-conditioning unit must be submitted for approval by the utility service which provides electricity (EN 61000-2 EN 61000-3 Norm). , IMPORTANT ￥ Please read this owner's manual before installing and carefully and thoroughly operating your room air conditioner. ￥ Please retain this owner's manual for future reference after reading it thoroughly. P/No.
Room Air Conditioner Owner's Manual TABLE OF CONTENTS FOR YOUR RECORDS Write the model and serial numbers here: Model # Serial # You can find them on a label on the side of each unit. Dealer's Name Date Purchased Staple your receipt to this page in the event you need purchase or for warranty issues. it to prove date of Safety Precautions .................3 Prior to Operation Operating ..................6 Instructions...........7 Remote Controller ..............
Precautions Safety Safety To to the prevent injury Precautions user or other people and property damage, the following instructions must be followed. Incorrect classified operation due to ignoring instruction by the following indications. WARNING This symbol CAUTION This symbol Meanings of symbols will indicates the indicates the used in this manual Be sure possibility possibility are as Be harm cause of or The seriousness is damage. of death serious or injury.
Safety Precautions Operation ? Do not operate pulling out the power It will cause or stop the unit by inserting Do not allow water to or run into electric parts. plug. electric shock or fire due to heat ? It may cause failure of machine or electric shock. generation. Do not operate with wet hands or in Do not direct airflow at damp room occupants only. environment. ? It may cause ? It may cause Do not It may use fire and electric shock accident.
Safety Precautions Operation Never touch the metal removing ? They are parts of the unit when Do not clean the air conditioner with water. the filter. sharp and may injury. cause Ventilate well when used ? together with When a An oxygen shortage may ? occur. Do not put a pet or house plant where it will be cause Do not exposed to direct air flow. are as the insulation. It turned off.
Prior to operation Prior to for Preparing 1. Contact 2. in the power Plug 3. Use installation an operation operation specialist for installation. plug properly. dedicated circuit. a 4. Do not use an 5. Do not start/stop operation by plugging/unplugging 6. If the extension cord. cord/plug is damaged, replace it with only an the power cord. authorized replacement part. Usage 1. Being exposed to direct airflow for an Do not expose occupants, pets, plants 2.
Operating Instructions Instructions Operating Remote Controller Remove the the arrow Insert of new battery battery batteries are Reattach the NOTICE Do not cover by pulling to according making sure correctly. that the and (+) (-) installed cover by sliding it back into position. Use 2 AAA(1.5volt) batteries. rechargeable batteries. use Storage and Tips For The remote control may be stored ? it direction. the Remote Control Using by mounting it ? on a wall.
Operating Instructions Remote Control The remote control transmits the Operation signals Signal to the system. 1 START/STOP BUTTON Operation starts when this button is pressed and stops when the button is pressed again. 2 OPERATION MODE SELECTION BUTTON Used to select the operation mode. 3 ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature. 4 INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS.
Operating Instructions Cooling Operation 1 Press the a 2 Start/Stop button. respond with The unit will beep. Open the door on the remote control. To select Cooling Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shiftedinthedirectionofthearrow. Auto Cooling 3 Close the door on lower than the room set within a Healthy Dehumidification Heating (Heat pump model only) the remote control. Set the temperature temperature.
Operating Instructions Auto Operation(Optional) Press the 1 Start/Stop button. respond with The unit will a 2 beep. Open the door on the remote control. To select Auto Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shiftedinthedirectionofthearrow.
Operating Auto Instructions Changeover Operation(Optional) 1 Press the a 2 Start/Stop button. respond with The unit will beep. Open the door on the remote control. To select Auto Changeover Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Auto Cooling 3 Close the door lower than the set within a changeover on Healthy Dehumidification Heating (Heat pump model only) the remote control.
Operating Instructions Healthy Dehumidification Operation Press the 1 Start/Stop button. respond with The unit will a 2 beep. Open the door the remote control. To select on Dehumidification Operation, press the Healthy Operation Mode Selection button. Each time the button is pressed, the operation mode is shiftedinthedirectionofthearrow. Auto Cooling 3 Set the fan speed again Heating (Heat pump model only) with the door of the remote control still closed.
Operating Heating Operation(Heat pump 1 Press the only) Start/Stop button. respond with The unit will a 2 model Instructions beep. Open the door on the remote control. To select Heating Operation, press the Operation Mode Selection button. Eachtimethebuttonispressed,theoperationmodeis shiftedinthedirectionofthearrow. Auto Cooling 3 Close the door Healthy Dehumidification on Heating (Heat pump model only) the remote control. Set the temperature higher than the room temperature.
Operating Instructions Jet Cool Operation Press the 1 Start/Stop button. respond with The unit will a 2 beep. Press the Jet Cool button to the will on 3 speed cooling operate mode and the unit operate in super high fan speed cooling mode for 30 minutes. To cancel the Jet Cool mode, press the Jet Cool button or room temperature setting button again and the unit will operate in high fan speed on cooling the fan speed button or the mode.
Operating PLASMA Purification 1 Instructions Operation(Optional) Press the Start/Stop button. respond with a The unit will beep. 2 3 Open the door on the remote control. Press the PLASMA air purifying operation ON/OFF button. Operation will start when the button is pressed and stop when the button is pressed again. Set the fan closed. You speed again with door of the remote control speed in four steps-low, medium, high or CHAOS.
Operating Instructions 2nd F Operation 1 Press the a 2 Start/Stop button. respond with The unit will beep. Open the door of the remote control and press the 2nd operate functions printed in blue at bottom Function button to of buttons. (Check the display.
Operating Instructions Additional features Sleep 1 Press the Mode To cancel the Sleep Mode, press the sleep Mode Auto button several times until the star Mode Auto button to set the Sleep time you want the unit to turn off automatically. ( 2 programmed in one-hour by pressing the Sleep Mode ) disappears from the operation display. The Timer is increments Auto NOTICE button 1 to 7 times. The mode is available for 1 to 7 times.
Instructions Operating Vertical Airflow Direction Control The up/down airflow (Vertical Airflow) adjusted by using the remote control. can be NOTICE If you press the CHAOS swing button, the horizontal airflow direction is changed automatically based on the CHAOS algorithm to and at the same distribute the air in the time to make the human room evenly body feel most as if enjoying a natural breeze. Always use the remote control to adjust the up/down airflow direction.
Operating Instructions Air Circulation Mode Circulates the 1 2 Press the Open air without room Start/Stop the door on cooling or button. the unit will heating. with respond beep. a the remote control. Press the Air Circulation button. Close the door remote control. Now each time that you press the Indoor Fan shifted from low to CHAOS and back to low again. CHAOS Air Fan speed is on low. Fan Speed Selector, speed is on medium.
Maintenance and Service Maintenance and Service CAUTION: Before performing any turn off the main power to the maintenance, system. Indoor Unit Never Grille, Case, and Remote Control Turn the off before system cleaning. clean, wipe with a soft, dry cloth. Do use bleach or ? To Could not before followings: deformation and/or cause Volatile substances Could Supply power must be disconnected cleaning any of the discoloration. abrasives.
Maintenance and Service Replacement of Purifying Filter(Optional) ? Recomended 1 Open use period front panel : About 2 years and remove air 2 Remove 3 Insert Triple deodorizing Filters. filters. new Triple deodorizing Filters. Air filter 2 3 4 Reinsert air filters and close front panel. Triple Deodorizing Filter Outdoor Unit The heat outdoor unit should be checked exchanger coils and panel vents of the regularly.
Maintenance and Service When the air conditioner is not going to be used for a When air conditioner is not used for to be going When the air conditioner is to be used long time. a Operate the air conditioner on unit. (Refer to page This will dry 20 for cleaning filters.) out the internal mechanisms. Turn off the circuit the again. Clean the air filter and install it in the indoor mode for 2 to 3hours. ? long time. breaker, and disconnect plug.
Maintenance and Service Troubleshooting Check the following points before requesting repairs or service.... If the fault persists, please contact your dealer or service center. Case The air conditioner does not operate. ? Have you made a mistake in timer operation? Has the fuse blown or has the circuit breaker been The room has a peculiar See page Explanation ? ? odor.
Memo 24 Room Air Conditioner
