ENGLISH Room Air Conditioner OWNER'S MANUAL BE01 Prior to installation, this air-conditioning unit must be submitted for approval by the utility service which provides electricity (EN 61000-3 Norm). êìëëäàâ üáõä • Please read carefully and thoroughly this manual before operating this unit. • Contact the authorized SVC man for repair or maintenance of this unit. • Contact the installer for installation of this unit.
Safety Precautions Safety precautions Safety Precautions Warning ................................2 Caution .................................3 Operating Instructions Preparation before operation ..4 Remote Control Features .....5 Operation Mode Selection ......6 Operating Instructions Additional features..............12 Care and Maintenance To prevent injury and property damage, follow these instructions.
• It may cause explosion, fire and, burn. Do not disassemble or modify products randomly. • It may cause failure and electric shock. ENGLISH Ventilate before operating air conditioner when gas goes out. Safety Precautions WARNING WARNING CAUTION CAUTION • They are sharp and may cause injury. When cleaning the unit, first make sure the power and breaker are turned off. • Since the fan rotates at high speed during operation, it may cause injury. • Water may enter the unit and degrade the insulation.
Safety Precautions Operating Instructions Care and Maintenance Troubleshooting Tips 4 Preparation before operation How to Insert the Batteries Remove the battery cover by pulling it according to the arrow direction. Insert new batteries making sure that the (+) and (-) of battery are installed correctly. Reattach the cover by sliding it back into position. NOTES: • Use 2 AAA(1.5volt) batteries. Do not use rechargeable batteries.
The remote control transmits the signals to the system. 1 START/STOP BUTTON Operation starts when this button is pressed and stops when the button is pressed again. 2 OPERATION MODE SELECTION BUTTON Used to select the operation mode. 3 ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature. 4 INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high, or CHAOS. 5 JET COOL/HEAT Used to start or stop the speed cooling or heating.
Safety Precautions Operating Instructions Care and Maintenance Troubleshooting Tips 6 How to use the Operation Mode Selection button Cooling Operation 1 Press the Start/Stop button. The unit will respond with a beep. 2 Open the door on the remote control. To select Cooling Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
Safety Precautions ENGLISH Auto Operation Press the Start/Stop button. The unit will respond with a beep. 2 Open the door on the remote control. To select Auto Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Healthy Dehumidification Heating (Heat pump model only) The temperature and fan speed are automatically set by the electronic controls based on the actual room temperature.
Safety Precautions Operating Instructions Care and Maintenance Troubleshooting Tips 8 Healthy Dehumidification Operation 1 Press the Start/Stop button. The unit will respond with a beep. 2 Open the door on the remote control. To select Healthy Dehumidification Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
2 Open the door on the remote control. To select Heating Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Healthy Heating Dehumidification (Heat pump model only) Close the door on the remote control. Set the temperature higher than the room temperature. The temperature can be set within a range of 16°C~30°C in 1°C increments.
Safety Precautions Troubleshooting Tips Care and Maintenance Operating Instructions Jet Cool Operation 10 1 Press the Start/Stop button. The unit will respond with a beep. 2 Press the Jet Cool button to operate the speed cooling mode and the unit will operate in super high fan speed on cooling mode for 30 minutes. 3 To cancel the Jet Cool mode, press the Jet Cool button again or the fan speed button or the room temperature setting button and the unit will operate in high fan speed on cooling mode.
Safety Precautions ENGLISH Jet Heat Operation 2 Press the Jet Heat button to operate the speed heating mode and the unit will operate in super high fan speed on heating mode for 60 minutes. 3 To cancel the Jet Heat mode, press the Jet Heat button again or the fan speed button or the room temperature setting button and the unit will operate in high fan speed on heating mode.
Safety Precautions Operating Instructions Care and Maintenance Troubleshooting Tips Additional features Sleep Mode 2 3 The Timer is programmed in one-hour increments by pressing the Sleep Mode Auto button 1 to 7 times. The sleep mode is available for 1 to 7 times. To alter the time period in steps of 1 hour, press the Sleep Mode Button while aiming at air conditioner. Note: The Sleep Mode will be operated at low fan speed (cooling) or medium fan speed (heat pump only) for quiet sleeping.
Press the button again and the louvers will stop. After 30 minutes, the louvers return to the maximum airflow position automatically. Circulates the room air without cooling or heating. 1 Press the Start/Stop button. the unit will respond with a beep. 2 Open the door on the remote control. Press the Air Circulation button. Close the door on the remote control. Now each time that you press the Indoor Fan Speed Selector, the fan speed is shifted from low to CHAOS and back to low again.
Safety Precautions Operating Instructions Forced Operation Operation procedures when the remote control can't be used. The operation will be started if the power button is pressed. If you want to stop operation, re-press the button. Cooling Model Operating mode Indoor FAN Speed Setting Temperature Cooling High 22°C Room Temp. ≥ 24°C Cooling High 22°C ˚C Power button Heat pump Model 21°C ≤ Room Temp. < 24°C Healthy Dehumidification High 23°C Room Temp.
CAUTION: Before performing any maintenance, turn off the main power to the system. Grille, Case, and Remote Control ❏ Never use any of the followings: • Water hotter than 40°C. Could cause deformation and/or discoloration. • Volatile substances Could damage the surfaces of the air conditioner. ❏ Turn the system off before cleaning. To clean, wipe with a soft, dry cloth. Do not use bleach or abrasives.
Safety Precautions When the air conditioner is not going to be used for a long time. When air conditioner is not going to be used for a long time. When the air conditioner is to be used again. Operate the air conditioner on Air circulation mode (Refer to page 13) for 2 to 3 hours. Clean the air filter and install it in the indoor unit. (Refer to page 15 for cleaning filters.) Troubleshooting Tips Care and Maintenance Operating Instructions • This will dry out the internal mechanisms.
Before you call for service... Troubleshooting Tips! Save time and money! Case Explanation See page The air conditioner does not operate. • Have you made a mistake in timer operation? • Has the fuse blown or has the circuit breaker been tripped? 12 It seems that condensation is leaking from the air conditioner. • Condensation occurs when the airflow from the air conditioner cools the warm room air. Air conditioner does not operate for about 3 minutes when restarted.
SUGGERIMENTI PER Tips Troubleshooting L’INDIVIDUAZIONE DEI PROBLEMI Care and Maintenance CURA E MANUTENZIONE Operating Instructions RUZIONI OPERATIVE Safety Precautions PRECAUZIONI DI SICUREZZA Memo
P/No.: 3828A20149D Printed in Korea After reading this manual, keep it in a place easily accessible to the user for future reference.