Room Air Conditioner OWNER'S MANUAL ? Please read before ? carefully and thoroughly operating this unit. Contact the authorized SVC man for this manual repair or maintenance of this unit. ? Contact the installer for installation of this unit. ? The is not intended for use by young infirm persons without supervision. children should be supervised to ensure that appliance children ? Young they do Prior to or not play with the appliance.
Safety precautions Safety Precautions Warning ................................2 To Caution .................................3 Incorrect operation damage, symbols. the seriousness of which is indicated before operation due to ignoring instructions will cause the by harm or following WARNING WARNING Instructions Operating Preparation prevent injury and property damage, follow these instructions. ..4 This symbol shows the possibility of death serious or injury.
WARNING WARNING Ventilate before operating air conditioner Do not disassemble when gas goes out. ? It may cause or modify products randomly. fire explosion, and, burn. ? It may cause failure and electric shock. CAUTION CAUTION Never touch the metal of the unit when parts removing Do not clean the air Ventilate well when used conditioner with water. together with a stove, etc. the filter. ? They are sharp injury.
before Preparation operation How to Insert the Batteries Remove the battery arrow direction. Insert new battery batteries are installed Reattach the cover cover by pulling making sure correctly. by sliding it according that the it back into (+) to the and of (-) position. NOTES: TroubleshtingpCadMcOISfyP 4 ? Use 2 AAA(1.5volt) batteries. Do not use rechargeable batteries. Storage and Tips For Using The remote control may be stored on a wall.
About the remote control The remote control transmits the signals to the on the system system. Features of the Remote Control- Door Signal 1 START/STOP BUTTON Operation starts when this button is pressed and stops when the button is pressed again. 2 OPERATION MODE SELECTION BUTTON Used to select the operation mode. 3 ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature. 4 INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS.
How to use the Operation Mode Selection button Cooling Operation 1 Press the a TroubleshtingpCadMcOISfyP 6 2 Start/Stop button. respond with The unit will beep. Open the door on the remote control. To select Cooling Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the Auto Cooling 3 Close the door lower than the set within a arrow.
Auto Operation Press the 1 Start/Stop button. respond with The unit will a 2 beep. Open the door on the remote control. To select Auto Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the Auto Cooling ON 3 The arrow. Healthy Dehumidification temperature and fan speed electronic controls based on are Heating (Heat pump model only) automatically the actual room set by the temperature.
Healthy Dehumidification Operation Press the 1 a TroubleshtingpCadMcOISfyP 8 Start/Stop button. respond with The unit will 2 beep. Open the door the remote control. To select on Dehumidification Operation, press the Healthy Operation Mode Selection button.
Heating Operation(Heat pump 1 Press the Start/Stop button. respond with beep. Open the door on Operation, press the remote control. To select the Each time the button Heating Operation Mode Selection button. is pressed, the operation mode is shifted in the direction of the Close the door arrow. Auto Cooling 3 only) The unit will a 2 model Healthy Dehumidification on Heating (Heat pump model only) the remote control. Set the temperature higher than the room temperature.
Jet Cool Operation 1 Press the a TroubleshtingpCadMcOISfyP 10 2 beep. Press the Jet Cool button to the will on 3 Start/Stop button. respond with The unit will speed cooling operate mode and the unit operate in super high fan speed cooling mode for 30 minutes. To cancel the Jet Cool mode, press the Jet Cool button or room temperature setting button again and the unit will operate in high fan speed on cooling the fan speed button or the mode.
PLASMA Purification 1 Operation(Optional) Press the Start/Stop button. respond with a The unit will beep. 2 3 Open the door on the remote control. Press the PLASMA air purifying operation ON/OFF button. Operation will start when the button is pressed and stop when the button is pressed again. Set the fan speed again closed. You with door of the remote control speed in four steps-low, medium, high or CHAOS. Each time the button is pressed, the fan speed mode is shifted.
2nd F Operation 1 Press the a TroubleshtingpCadMcOISfyP 12 2 Start/Stop button. respond with The unit will beep. Open the door of the remote control and press the 2nd operate functions printed in blue at bottom Function button to of buttons. (Check the display.
Additional features Mode Sleep 1 Press the Sleep To cancel the Sleep Mode, press the sleep Mode Auto button several times until the star Mode Auto button to set the time you want the unit to turn off automatically. ( 2 programmed in one-hour by pressing the Sleep Mode ) disappears increments Auto The Sleep Mode will be operated at speed (cooling) or medium fan speed (heat pump only) for quiet sleeping. the Sleep slow fan mode is available for 1 to 7 times.
Vertical Airflow Direction Control The up/down airflow (Vertical Airflow) adjusted by using the remote control. be can Note: If you press the CHAOS swing button, the horizontal airflow direction is changed automatically based on the CHAOS TroubleshtingpCadMcOISfyP 14 algorithm to distribute the air in the room evenly and at the same time to make the human body feel most comfortable, as if enjoying a natural breeze. Always use the remote control to adjust the up/down airflow direction.
Forced Operation Operation procedures when the remote control can't be used. The operation will pressed. be started if the power button is If you want to the button. stop operation, re-press Power button Open the front panel upward Cooling Model Operating mode Indoor FAN Speed Setting Temperature Test Heat pump Model Room Temp. ≥ 24°C2 1 °C ≤ Room Cooling Cooling High High Healthy Temp. < 24°C Dehumidification High Room Temp.
Telephone Control Operation(Optional) Calling from outside, you can start the air conditioner to keep the room comfortable. Even though you went out with the air conditioner on, you can turn it off using the phone Dial the number which is connected with the air TURN ON 1 conditioner. After You TroubleshtingpCadMcOISfyP 16 outside. is 5 times. ringing can When hear the "Beep" sound then press "0" "0" "7" "8" off), using along OGM with ARS (if the air conditioner accordingly.
Care and maintenance of the air conditioner CAUTION: Before performing any maintenance, turn off the main power to the system. Indoor Unit Never Grille, Case, and Remote Control ? Turn the system off before cleaning. To clean, wipe with a soft, dry cloth. Do not use bleach or use any of the followings: Water hotter than 40°C Could deformation and/or cause discoloration. abrasives. ? Volatile substances NOTE: Could Supply power must be disconnected before cleaning the indoor unit.
Replacement of Purifying Filter(Option) ? Recomended 1 Open use period front panel : About 2 years and remove air 2 Remove air 3 Insert purifying filters. filters. new air purifying filters. Air filter TroubleshtingpCadMcOISfyP 18 2 3 4 Reinsert air filters and close front panel. Air purifying filter Outdoor Unit The heat exchanger coils and panel vents of the regularly.
When the air conditioner is not going to be used for a long time. When air conditioner is not used for going to be When the air conditioner is to be used long time. a Clean the air filter and install it in the indoor Operate the air conditioner on Air circulation mode (Refer to page 14) for 2 to 3 hours. unit. (Refer to page ? This will dry 17 for cleaning filters.) out the internal mechanisms. Turn off the circuit the again. breaker, and disconnect plug.
Before you call for service... Troubleshooting Tips! Save ? Check the following points contact your dealer or before The air conditioner does not operate. ? TroubleshtingpCadMcOISfyP 20 a service.... If the fault peculiar ? odor. persists, please See page 13 Have you made a mistake in timer operation? Has the fuse blown or has the circuit breaker been has or Explanation ? room requesting repairs money! service center.
Memo 21
Memo 22
P/No.: 3828A20243G After reading this manual, Printed in Korea keep it in a place easily accessible to the user for future reference.
