Owner’s Manual

28 OPERATION
the display. For example, select Conv. Bake, enter
350 ℉, and 325 ℉ shows on the display after
preheat.
Convection Auto Conversion is enabled by default.
To change the setting, follow these instructions.
1 Press Settings repeatedly until Auto appears
in the display.
2 Press 1 to disable or enable auto conversion.
3 Press START to accept the change.
Adjusting the Oven Thermostat
Your new oven may cook differently from the one
it replaced. Use your new oven for a few weeks to
become more familiar with it before changing the
temperature settings. If after familiarizing yourself
with the new oven, you still think that it is too hot
or too cold, you can adjust the oven thermostat
yourself.
• To begin, either raise or lower the thermostat
15℉ (8 ℃). Try the oven with the new setting. If
the oven still needs adjustment, raise or lower
the thermostat again, using the first adjustment
as a gauge. For example, if the adjustment was
too much, raise or lower the thermostat 10 ℉ (5
℃). If the adjustment was not enough, raise or
lower the thermostat 20 ℉ (12 ℃). Proceed in
this way until the oven is adjusted to your
satisfaction.
1 Press Settings repeatedly until AdJU appears
in the display.
2 Use the number buttons to enter the number
of degrees you want to adjust the oven
temperature.
3 Adjust the temperature either up or down by
pressing Settings repeatedly to toggle
between plus (+) or minus (-).
4 Press START to accept the change.
NOTE
• This adjustment does not affect the broiling or
Self Clean temperatures. The adjustment is
retained in memory after a power failure. The
oven temperature can be increased (+) or
decreased (-) as much as 35 ℉ or 19 ℃.
• Once the temperature is increased or decreased,
the display shows the adjusted temperature
until it readjusts.
Turning the Preheat Alarm Light On/Off
When the oven reaches its set-temperature, the
preheating alarm light flashes 5 times or until the
oven door is opened.
You can activate or deactivate the preheating
alarm light.
1 Press Settings repeatedly until PrE appears in
the display.
2 Press 1 to turn the light on/off.
3 Press START to accept the change.
Adjusting the Beeper Volume
1 Press Settings repeatedly until Beep appears
in the display.
2 Press 1 to select Hi, Lo or Off.
3 Press START to accept the change.
Selecting Fahrenheit or Celsius
Set the oven temperature display to show either
Fahrenheit (℉) or Celsius (℃) units. The oven
defaults to Fahrenheit unless changed by the user.
1 Press Settings repeatedly until Unit appears
in the display.
2 Press 1 to select F (Fahrenheit) or C (Celsius).
3 Press START to accept the change.
Adjusting Cooktop On Alert Volume
1 Press Settings repeatedly until CtOP appears
in the display.
2 Press 1 to select Hi, Lo, Off.
3 Press START to accept the change.