Owner's Manual

20 INSTALLATION

3 Attach the ground (green) bare wire end to

the range frame and secure it in place with

the ground screw.

4 Insert the bare wire (white/neutral) end

through the center terminal block opening.

The center screw now attaches the bent up

ground strap to the block.

5 Insert the two side bare wire ends into the left

and the right terminal block openings.

Tighten the 3 screws securely into the

terminal block. (approximately 35 - 50 IN-LB)

a Black

b White

c Red

d Terminal block

e Wire ends

f Ground strap

g Conduit connection plate

h Ground screw

i Ground wire

Optional Rear Filler

Installing the Rear Filler

If the counter does not bridge the opening at the

rear wall, the rear filler kit which is provided with

the slide in range will be needed.

NOTE

• If the countertop depth is greater than 25 3/8"

there will be a gap between the filler kit and the

back wall.

• If the countertop depth is less than 24 3/4", the

control panel will not sit flush with the

countertop.

1 Using a screwdriver, remove the three screws

holding the rear top plate in place.

a Rear Top Plate

2 Attach the rear top plate and filler assembly

as shown, using three screws removed in step

b Rear filler

us_main.book.book Page 20 Wednesday, February 3, 2021 9:14 AM