ENGLISH ESPAÑOL INSTALLATION MANUAL ELECTRIC RANGE Please read these instructions thoroughly before installing and operating the range. LSES302S LSRE307S P/No.: MFL57205803 www.lge.
Part 1 SAFETY 1 BEFORE YOU BEGIN Remove all tape and packing materials before using the range. Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. IMPORTANT SAFETY INSTRUCTIONS Glasses Read and follow all instructions before using your oven to prevent the riskSafety of fire, electric shock, personal injury, or damage when using the range. This guide does not cover all possible conditions that may occur.
Part 1 SAFETY Safety Glasses Tape Measure • The information in this manual should be followed exactly. Gloves Pencil Safety Glasses TOOLS NEEDED Tape Measure - A fire or electrical shock may result causing property damage, personal injury or death. Safety Glasses Pencil Gloves Tape Measure WARNING Gloves Pencil • DO NOT step or sit on oven door. Install the Anti-Tip Bracket supplied with the range.
Part 2 PREPARE TO INSTALL THE RANGE 2 INSTALLATION DRAWINGS (LSRE Series only) NOTE SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. CLEARANCES AND DIMENSIONS (Figure 1) To install range refer to the following Figure 1. Safety Glasses For installation in CANADA, a Free-standing range is not to be installed closer than 15/32 (12mm) from any adjacent surface.
Part 2 PREPARE TO INSTALL THE RANGE ENGLISH 2 INSTALLATION DRAWINGS (LSES Series only) NOTE SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. CLEARANCES AND DIMENSIONS (Figure 1) To install range refer to the following Figure 1. Safety Glasses For installation in CANADA, a Free-standing range is not to be installed closer than 15/32 (12mm) from any adjacent surface.
Part 3 ELECTRICAL CONNECTIONS 3 ELECTRICAL CONNECTION 4 C ONNECT RANGE CORD REQUIREMENTS The Rear Access cover must be removed. Loosen the three screws with a screwdriver. The terminal block will then be accessible. This appliance must be installed and grounded on a branch circuit by a qualified technician in accordance with the National Electrical code ANSI/NFPA NO. 70 latest edition. All wiring should conform to Local and NEC. This range requires a single-phase, 3 wire, A.
Part 3 ELECTRICAL CONNECTIONS Tape Measure WARNING Gloves Pencil • The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main terminal block. The remaining two wires of the power cord or conduit have to be connected to the outside posts of the main terminal connection block. - Failure to do so can result in electrical shock, severe personal injury or death.
Part 3 ELECTRICAL CONNECTIONS Safety Glasses 4-wire connection with a power supply cord 3-wire connection: conduit Tape Measure Install the conduit as follows: WARNING Pencil Remove the Conduit connection Gloves plate from the rear of drawer body and rotate it as shown in Figure 5. The conduit hole (11/8”) must be used.
Part 3 ELECTRICAL CONNECTIONS 1. F ollow the instructions under “Install the conduit as follows” on page 7 to correctly install the strain relief. DO NOT install the conduit without a strain relief. 2. Loosen the 2 lower left and right screws from the terminal block. (Refer to Figure 12.) Remove the lower 2 center screws. 3. Remove ground strap and discard as shown in Figure 12. Do not discard any screws. 4.
Part 4 INSTALL THE RANGE Replace the access cover on the range back. To replace the wire cover, insert double projections in the pockets located below the opening and tighten the three screws. Safety Glasses Tape Measure 5 ANTI-TIP DEVICE INSTALLATION Pencil Use a spirit level to check your adjustments. Place the level diagonally on the oven rack, check each Safetyand Glasses direction for level.
To contact LG Electronics 24 hours a day, 7 days a week: Para comunicarse con LG Electronics 24 horas al día, 7 días a la semana: 1-800-243-0000 (USA) Or visit us on the Web at: u s.lge.com (USA) 1-800-243-0000 (EE.UU.) O visítenos en la Web en: u s.lge.com (EE.UU.
