Installation Manual

– 13 –
STEP 5: INSTALL THE MOUNTING PLATE
C
B
A
Wall
Mounting
Plate
Space More Than Wall Thickness
Bolt
End
Toggle Bolt
Toggle Wings1
3/16 Hole on Studs
5/8 Hole on Drywall Only
Minimum 66
From the Floor
For Wall -
Venting Only
Draw Lines
on Studs
Draw
Center Line
Center Line
Mounting Plate
Support Tab
Support Tab
The Oven Must Be Connected To At Least One
Wall Stud.
1. Center the rear wall template in the space by lining up
the plumb line on wall with centerline on template.Then
securely tape or tack the rear wall template in place.Make
sure the minimum width is 30 inches and that the top of the
rear wall template is located a minimum of 30 inches above
the cooking surface. See Figure 24.
NOTE: If the cabinets are not plumb, adjust the rear wall
template to the cabinets. If the front edge of the
cabinet is lower than the back edge, adjust the
template to be level with the cabinet front.
2. Drill holes at points A, B. Drill the third hole inside area C,
through one of the bottom holes to match the location of
a stud. If there is a stud, drill a 3/16 hole for lag screws.
If there is no stud, drill a 5/8 hole for toggle bolts. These
holes must be used for mounting. If the holes are not used,
the installation will not be secure. Installer must use these
holes for proper installation. See Figure 28. Use toggle
bolts through these holes, unless one of them lines up with
a stud. Use a wood screw for studs. Make sure to use at
least 1 lag screw in a stud, and 2 toggle bolts in the drywall
or the plaster.
NOTE: Cut out the shaded area marked F on the REAR
WALL TEMPLATE for wall-venting.
3. Remove the template from the rear wall.
4. Attach the plate to the wall. To use spring toggle head
bolts: Remove the toggle wings from the bolts. Insert the
bolts into the mounting plate and replace the spring toggle
head to 3/4 past the bolt ends. Insert the spring toggle
head into the holes in the wall to mount the plate. You may
pull forward on the plate to help in tightening the toggle
bolts. Tighten all bolts. See Figure 29.
Figure 29
Figure 28