website http://www.lgservice.com LG LG Room Air Conditioner OWNER'S MANUAL MODELS : SQ/SR/ST Chassis IMPORTANT ? ? Please read this owner's manual and before air conditioner. installing and carefully operating your room thoroughly Please retain this owner's manual for future reference after reading it thoroughly.
Room Air Conditioner Owner Manual TABLE OF CONTENTS FOR YOUR RECORDS Safety Precautions.........................3 Write the model and serial numbers here: Model # Prior to Operation ..........................9 Serial # You find them can on a label on the side of each unit. Dealer's Name Introduction ..................................10 Date Purchased your receipt to this page in the event you need it to prove date of purchase or for warranty issues. Staple Electrical Operating Safety ..
Safety Precautions Precautions Safety To prevent the injury of the user or other people and property damage, the following instructions must be followed. Incorrect operation due to ignoring following indications. the The meanings of the instruction will cause harm or damage.
Precautions Safety Be cautious when and installing the For unpacking product. Do not install the installation, always contact the dealer or an a product on defective installation stand. Authorized Service Center. ? Shape edges Be especially edges. Be sure could injury. sharp cause ? careful of the the installation There is risk of explosion, or fire, electric shock, ? injury. It may cause damage injury, accident, product.
Safety Precautions Use a dedicated outlet for this appliance. ? There is risk of fire or electric cord from the outlet. Do not Grasp the plug Do not place a heater or other appliances near the power touch it with wet hands. cable. ? shock. There is risk of fire remove or the electric ? There is risk of fire, failure of the shock. Do not allow water to electric to run into product, Do not store of Do not use flammable gas or combustibles near the air part.
Safety Precautions Do not open the inlet grill of product during operation. When the the (flooded (Do not touch the contact electrostatic is ? so filter, if the unit product is soaked submerged), Ventilate the or an Authorized with stove, etc. appliance together Service Center. equipped.) There is risk of electric shock, physical injury, product. ? There is risk of electrical shock. ? An oxygen shortage may occur.
Safety Precautions Do not install the where the noise product or hot air from the outdoor unit could Use two and or more people to lift transport the air Do not install the product exposed to (salt spray) directly. where it will be conditioner sea wind damage the neighborhoods. It may ? cause a for your problem ? Avoid ? personal injury. It may cause corrosion in the ENGLISH product. Corrosion, particularly on neighbors.
Safety Precautions Always insert the filter securely. Clean the filter every two weeks or often if necessary. A ? dirty filter more reduces the efficiency malfunction product damage. Use a firm stool maintaining or ? or other Do not drink the water the air inlet drained from the unit. outlet while the air There plugged are sharp that could cause in. and moving parts personal injury. ? It is not sanitary and could cause serious health issues.
Prior to Prior to for Preparing 1. Contact 2. 3. Use an Operation Operation installation in the power Plug operation specialist plug properly. ENGLISH for installation. dedicated circuit. a 4. Do not use an extension cord. 5. Do not 6. If the start/stop operation by plugging/unplugging the power cord. cord/plug is damaged, ony replace it with an authorized replacement part. Usage 1. Being exposed to direct airflow for occupants, pets, 2. Ventilate the supply 3.
Introduction Introduction Symbols used in this Manual This symbol alerts you to the risk of electric shock. This symbol alerts you to hazards that may cause harm to the air conditioner. NOTICE This symbol indicates notes. special Features ? This as a appliance should be installed in accordance guide to help to explain product features. with national wiring regulations.
Electrical Electrical ? This appliance must be Safety properly grounded. To minimize the risk of electric ? Do not cut ? Attaching the unless the house or remove the shock, you must alway plug prong from the power grounding adapter ground cover screw terminal to the wall is metal and not into a grounded oulet plug. receptacle cover screw does not ground the appliance insulated, and the wall receptacle is grounded through the wiring.
Operating Instruction Instruction Operating How to insert the Batteries Remove the the arrow Insert of new battery battery cover by pulling it according to direction. batteries are Reattach the making sure that the (+) correctly. and (-) installed cover by sliding it back into position. NOTICE Use 2 AAA(1.5volt) batteries. Do not use rechargeable batteries. Storage and Tips ? For The remote controler may be stored a wall.
Operating Remote Control Instruction Operations The controls will look like the following. Signal transmitter 1. START/STOP BUTTON Operation starts when this button is pressed and stops when the button is pressed again. 2. OPERATION MODE SELECTION BUTTON Used to select the operation mode. ENGLISH 3. ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature. 4. INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps low, medium, high and CHAOS. 5.
Operating Instruction Cooling Operation 1 2 Press the Start/Stop button. respond with The unit will a beep. Open the door on the remote control. To select Cooling Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the Auto Cooling 3 on lower than the room a Set the fan Heating (Heat pump model only) the remote control. Set the temperature temperature.
Operating Auto Instruction Operation 1 Press the a 2 Start/Stop The unit will respond ENGLISH button. with beep. Open the door on the remote control. To select Auto Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
Operating Instruction Healthy Dehumidification Operation Press the 1 Mode Start/Stop button. respond with The unit will a beep. Open 2 the door on the remote control. To select Dehumidification Operation, Healthy Operation Mode Selection button. Each time the button is pressed, shifted in the direction of the Set the fan 3 the operation mode is arrow.
Operating Heating Operation (Heat pump model Press the Instruction only) ENGLISH Start/Stop button. respond with 1 The unit will 2 Open the door on the remote control. To select Heating Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is a beep. shifted in the direction of the Auto Cooling 3 Close the door arrow. Healthy Dehumidification on Heating (Heat pump model only) the remote control.
Operating Instruction Jet Cool Operation Press the Start/Stop button. respond with 1 The unit will 2 the a beep. Press the Jet Cool button to will on 3 speed cooling operate mode and the unit operate in super high fan speed cooling mode for 30 minutes. To cancel the Jet Cool mode, press the Jet Cool button or room temperature setting button again and the unit will operate in high fan speed on cooling the fan speed button or the mode.
Operating NANO PLASMA Purification 1 2 3 Instruction Operation (Optional) Press the ENGLISH Start/Stop button. respond with a The unit will beep. Open the door on the remote control. Press the PLASMA button. Operation will start when the button is pressed and stop when the button is pressed again. Set the fan speed again closed. You with door of the remote control speed in four steps-low, medium, high or CHAOS. Each time the button is pressed, the fan speed mode is shifted.
Operating Instruction 2nd F Operation 1 2 Press the Start/Stop button. respond with The unit will a beep. Open the door of the remote control and press the 2nd operate functions printed in blue at bottom Function button to of buttons. (Check the display.
Operating Instruction Additional features Sleep 1. Press the Mode Sleep Mode Auto button to set the time you want the unit to turn off automatically. To cancel the Sleep Mode, press the sleep Mode Auto button several times until the star ) disappears from ( programmed in one-hour increments by pressing the Sleep Mode Auto button 1 to 7 the operation display. 2. The Timer is NOTICE times.
Operating Instruction Vertical Airflow Direction Control The up/down airflow (Vertical Airflow) by using the remote control. can be adjusted NOTICE If you press the CHAOS swing button, the vertical airflow direction is changed automatically based on the CHAOS algorithm and at the most Start/Stop to distribute the air in the time to make the human comfortable, as button to start the unit. use 2.Open Press Chaos on a natural breeze. conditioner.
Instruction Operating Forced Operation Operation procedures when ENGLISH the remote control can't be used. The will be started if the power button is operation If you want to pressed. stop operation, re-press the button. Power button Open the front panel upward Heat pump Model Cooling Model Room Temp. ≥ 24°C2 1 °C ≤ Room Operating mode Cooling Cooling Indoor FAN Speed High High Test operation During the TEST temperature and test Temp.
Maintenance and Service Maintenance and Service Before performing turn off the main power to the maintenance, any system. Indoor Unit Grille, Case, and Remote Control Turn the system off before cleaning. To clean, wipe with cloth. Do not use bleach or a soft, dry abrasives. NOTICE Supply Air inlet vent power must be disconnected before cleaning Air outlet vent the indoor unit.
Maintenance and Service Replacement of purifying Recomended 1. Open use front period panel : filter (Optional) About 2 years and remove air filters. ENGLISH Air filter 2. Remove air purifying filters. 2 3. Insert new air purifying filters. 4. Reinsert air filters and close front 3 panel.
Maintenance and Service Common Problems and Solutions Before for service calling If you have problems with cannot find a solution, your air conditioner, read the following information and try Air conditioner does not or voltage Air does not feel cold 2. Check to see into plugged a proper outlet. circuit breaker. 3. Check whether the 1. Ensure that the is unusually high enough if the air filter is the on temperature settings are clogged or low. cooling setting correct.
Maintenance and Service Troubleshooting The air conditioner may be Problem operating abnormally when: Possible Causes The air conditioner is What To Do ? unplugged. The fuse is blown/circuit breaker is ? sure the air conditioner plug ENGLISH is into the outlet. Check the house fuse/circuit breaker box and tripped. Air Make pushed completely replace the fuse or reset the breaker. conditioner does not start Power failure. ? If power failure occurs, turn the mode control to Off.
P/No.: 3828A21011A After reading this manual, keep Printed in Korea it in a place easily accessible to the user for future reference.
