OWNER’S MANUAL Wall Mounting Bracket Please read this manual carefully before operating your set and retain it for future reference. LSW100B LSW100BG P/NO : MFL63640503 (1112-REV07) www.lg.
* 1 Year Warranty (Europe : 2 Year) If material or workmanship proves defective under normal use, during the warranty period, please contact the retailer where you purchased it. This warranty is good only to the original purchaser of the product and effective only in the local area.
s ENGLISH Caution Install the product according to the directions in the user manual. If the product is not installed based on the directions in the user manual, it can cause a serious injury or damage to the product. When installing the product or adjusting the height of the product after installing, always do so with 2 people. Working alone can cause the product to fall off and result in injury or damage to the product.
Installation method - Tools you will need : Phillips head "+" driver(Manual or motorized) Ø4mm drill bit for wood or steel / Level / Stud finder / Drill. You may also need an 8mm socket wrench or an 8mm drill bit for concrete. 1 Separating the TV bracket 1 3 2 Safety pin 1. After expanding the wall mount forward as shown in Fig. 1, separate the safety pin from the wall mount as shown in Fig. 2. 2. Separate the set bracket as shown in Fig. 3.
How to attach to masonry walls - Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and hallow block that do not crack. Please follow the below direction. - Check the material of the wall and the thickness of the finishing. - When installing the product on the wooden wall, refer to page 6.
drywall 76mm 406mm wood stud drywall a. Locate and mark the centers of the wall studs using a stud finder. b. After aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and then remove the wall bracket. c. Use a level to make sure your screw marks are level. d. Use the 4mm drill bit for wood to drill holes with the depth of 76mm or above where the wall mount screw location is marked on the wall. e.
[ Unit : mm ] -15° ~ +15° ± 2° -15° ~ +15° ± 2° Max. Min. 116 20 Max. Min. LSW100B/LSW100BG Model Name LSW100B/LSW100BG Width (mm) 221 Width (mm) 435 Height (mm) 152 Height (mm) 167 Depth (mm) 14 Depth (mm) 20 Model Name Weight (kg) 0.9 Weight (kg) 1.7 Wall Mount VESA Specification 100 X 100/200 X 100 Wall Mount VESA Specification 100 X 100/200 X 100 15 Max.
The model and serial number of the product is located on the back or one side of the product. Record it below should you ever need service. MODEL SERIAL Supported Displays: (Please contract the retailers or refer to the TV owner’s manual for applicable models.
