Owner's Manual

12 Operation and settings
Stream
Master/Slave
> Enable: Click to activate the stream function.
> Deinterlacing: Click to activate the deinterlacing function.
> Video codec: Select the video mode (Codec) from the drop
down list. The viewer can choose between MJPEG and H.264.
> Resolution: Select the output image size of the camera.
> Maximum frame rate: Set the frame rate of the image.
> GOP size: It means “Group of Pictures”. The higher the GOP, the
better is the video quality of the camera. Edit the value of GOP
from 1 to 30. This setting is valid for H.264 video format only.
> Quality: Select the Quality.
- VBR: The bit rate may vary depending on the complexity of
the video to meet the selected quality.
- CBR: The video quality may vary in order to preserve a
constant bit rate.
> Stream quality: If the [Quality] option set to VBR, this option is
displayed. Select the stream quality from the drop down box,
the camera supports five types. (Highest, High, Medium, Low
and Lowest)
> Bit rate: If the [Quality] option set to CBR, this option is
displayed. Edit the bit rate value from 256 kbps to 10 240 kbps.
Note:
If the ‘Bit rate’ is configured too low with high resolution, the
actual frame rate will decrease because of narrow bandwidth.
So you need to set or change the ‘Bit rate’ to high value.
• Save: Click this button to confirm the settings.
Audio (Option)
Audio In
> Enable: Click the check box if you want to send the audio from
the microphone input connector.
Note:
The Clients connected to the IP device remain unaffected with
additional changes made in the setting.
> Audio type: Select the codec when you send the audio from
the microphone input connector.
Audio Out
> Enable: Click the check box to output the audio from the
speaker.
• Save: Click this button to confirm the settings.