2021 1717K

ManualsBrandsLG ManualsSide by Side RefrigeratorsLSXC22426S

13INSTALLATION

ENGLISH

Unpacking the Refrigerator

Water

Electricity

Flooring

Ambient Temperature

WARNING

NOTE

• Use two or more people to move and install the

refrigerator. Failure to do so can result in back

injury or other injury.

• The refrigerator is heavy. Protect the oor when

moving the refrigerator for cleaning or service.

Always pull the refrigerator straight out when

moving it. Do not wiggle or walk the refrigerator

when trying to move it, as oor damage could

occur.

• Keep ammable materials and vapors, such as

gasoline, away from the refrigerator. Failure to

do so can result in re, explosion, or death.

• The water pressure must be 20 - 120 psi or 138 -

827 kPa or 1.4 - 8.4 kgf/cm2. If the refrigerator is

installed in an area with low water pressure

(below 20 psi or 138 kPa or 1.4 kgf/cm2), you can

install a booster pump to compensate for the

low pressure.

• Installing on carpeting, soft tile surfaces, a

platform or weakly supported structure is not

recommended.

• Do not overload house wiring and cause a re

hazard by plugging in multiple appliances in the

same outlet with the refrigerator.

• To reduce the risk of electric shock, do not install

the refrigerator in a wet or damp area.

Water supply must be easily connected for the

automatic icemaker.

Use an individual, grounded outlet:115 Volts, 60

Hz, AC, 15 Amps minimum.

To avoid noise and vibration, the unit must be

installed and leveled on a solidly constructed oor.

If required, adjust the leveling legs to compensate

for the unevenness of the oor.

Install this appliance in an area where the

temperature is between 55 °F (13 °C) and 110 °F

(43 °C).

If the temperature around the appliance is too low

or high, cooling ability may be adversely aected.

• Remove tape and any temporary labels from

your refrigerator before using. Do not remove

any warning labels, the model and serial number

label, or the Tech Sheet that is located under the

front of the refrigerator.

• To remove any remaining tape or glue, rub the

area briskly with your thumb. Tape or glue

residue can also be easily removed by rubbing a

small amount of liquid dish soap over the

adhesive with your ngers. Wipe with warm

water and dry.

• Do not use sharp instruments, rubbing alcohol,

ammable uids, or abrasive cleaners to remove

tape or glue. These products can damage the

surface of your refrigerator.

• Reinstall or adjust shelves as needed.

Refrigerator shelves are installed in the shipping

position. Reinstall shelves according to your

individual storage needs.

Choosing the Proper

Location