Owner's Manual

Operation unit
Humidify JET
AUTO
Program set
Room Temp
MED
LO
Heater
Defrost
Filter
Preheat
Out door
Time
Timer
On
Set no. Time
Off
01 03 05 07 09 11 13 15 17 19 21 23
Timer Cancel
Program Week
Hour Min
Holiday
SET/CLR
RESET
Plasma
ZONE
1234
AUTO SWING OPERATION FAN SPEED SUB FUNCTION SET TEMP
HI
Plasma
Owner's Manual 27
Operating Instructions
Press the On/Off button. The
unit will respond with a beep.
1
Open the door on the remote control.
Press the PLASMA air purifying
operation ON/OFF button.
Operation will start when
the button is pressed and stop
when the button is pressed again.
2
Set the fan speed again with door of the remote
control closed. You can select the fan speed in
four steps-low, medium, high or Auto.
Each time the button is pressed, the fan speed
mode is shifted.
✴ Air purifying operation (PLASMA)
with cooling, heating or any
other operations.
3
Tips for Filter sign LED
1. Filter sign lamp (LED) is ON.
2. If LED indicating filter sign lamp is ON, clean the filter.
3. After cleaning the filter, press the Timer button and ◀ button of wired remote controller at
the same time for 3 sec.
Then filter sign LED is OFF.
PLASMA Purification Operation (Optional)