Owner’s Manual

13
EN
3
Remove the backing from the vertical
insulation strip 15-9/16” x 1-3/8” x 1-3/8” and
attach that to the inside right of the sleeve
as shown below. Remove the backing from
the around insulation strip 67-1/8” x 1-3/8” x
25/32” and attach that to the inside front of the
sleeve as shown below.
Around Insulation
Vertical Insulation
9
1
/
2
"6"
Indoor Outdoor
Figure 7
4
Install the new unit into the wall sleeve.
5
To assemble trim, snap the tab of each piece
into the slot of the other piece as shown below.
Slide trim over the front of the Air Conditioner
until trim is flush with sleeve as shown below.
Wall
Trim (2 ea)
Figure 8
CAUTION
• Air Conditioners covered in this manual pose
an excessive weight hazard. Two or more
people are needed to move and install the unit.
To prevent injury or strain, use proper lifting
and carrying techniques when moving unit.
• When handling the Air Conditioner, be careful
to avoid cuts from sharp metal fins on front and
rear coils.
• Make sure Air Conditioner does not fall during
removal.
• If unit does not operate after installation check,
to be sure the circuit interrupter has not been
tripped. Refer to the Troubleshooting guide for
reset procedure.
Procedure B
1
Redirect the louvers at the back of the wall
sleeve to 60° angle as shown in the Figure 9.
The use of pliers is recommended.
Figure 9
Rear Louvers
(Top View)
60°
60°
7
3
/
32
"
2
If the wall sleeve already has a rear grille, skip
to step 4. If the wall sleeve does not have a
rear grille or louvered panel, install the plastic
grille from the kit. Cut the plastic grille to 25-
1/2” wide and 15-1/4” high. Place the plastic
grille to the inside of the wall sleeve at the rear
flange.
Placethe plasticgrille
Figure 10