Owner’s Manual

Hinge Pin
Insert
Hinge
Pin Bracket
Door
Closer/
Stop
Door
Closer/
Stop
Hinge Pin
Insert
Hinge
Pin Bracket
REATTACHING THE DOORS
Place the freezer door down over the Hinge Pin on the
Middle Hinge Pin Bracket.
Middle Hinge
Bracket
Flange
Decorative
Screw
REFRIGERATOR INSTALLATION
Flip the Middle Hinge Bracket, (flange will now be on top)
position it on left side of the refrigerator and reattach with
two bolts and a Phillips screwdriver. Place the refrigerator
door down over the pin on the bottom hinge. Place the
washer between the refrigerator door and middle hinge
and re-attach Hinge Pin to Hinge Bracket with a ¼”
socket wrench.
NOTE: Bracket has been flipped, but Hinge Pin stays in
the same orientation with its hexagonal end facing
upward.
Insert the Decorative Screw into the outer hole on the
right side of the housing. Attach cover on the right side.
Cover is force-fitted.
Place the Upper Hinge Pin on top of the freezer door and
line up the Upper Hinge with holes on top of the refrig-
erator. Use the three bolts to replace the Hinge.
Reverse the Door Closer/Stop by flipping it over. Place it
on top of the Hinge Pin Insert Bracket, and tighten both
down with the screw. Tighten the Hinge Pin Bracket to the
door.
NOTE: The Door Closer Stop is only presented on some
models.
With a flat-head screwdriver, carefully pry off and remove
the cover over the screw holes on the left side of refrig-
erator housing.
Remove the outer lower Decorative Screw from the hous-
ing at the area between the freezer and refrigerator doors.
(You will need this hole for the Middle Hinge Bracket.)
11