Owner's Manual

Connect a DC 12V power source to the Power Input Jack of the camera as
shown below.
105mm
140
96.5
① Pushing part of base arrow pointed turn the part B counter clock
simultaneously to remove the base deco.
② Roosen the lock screw to remove the dome cover
③ Widen the cover with both hands then remove the cover.
④ Adjust Near&Far, Wide&Tele as you wish Then install base deco,
screw, inner dome in reverse order.
Step2 Step3 Step4
Step1
SCREW
*If you use the video output with service output
(jack) at the same time, it may falls off the signal output
(Output)