Operating Instructions LVC-D10NE LVC-D10NC LVC-D100NM LVC-D100NP Before please the camera, read these instructions thoroughly installing and using and retain them for later reference.
Regulatory RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Safetyprecautions..........................4 What'sinthebox...........................5 Construction.............................6-7 ?Frontview...............................6 ?Sideview................................6 ?Rearview................................7 Installation...............................8-9 ?Camerainstallation.......................8-9 Troubleshooting............................10 Dimension................................11 Specifications..........................
Safety Precautions Do not attempt to disassemble the camera Avoid camera To prevent electric shock, do not remove screws or covers. There are Do not aim the objects. Never serviceable parts inside. Contact qualified service personnel for repair. Do not use solvents or sunlight camera at bright strong detergents Handle the with care Use a dry cloth to clean the camera when it is dirty.
What's in the box Video Cable Tapping Screws (2EA) (Pan Lock Screw) M4 Camera Body 60 ft cable (RJ11: LVC-D10NE/NC RJ45: LVC-D100NM/NP) 5
Construction Front View LG logo Tilt Base Focus Lock Screw Side View Dome Cover Lens Tilting Lock Screw Dome Cover Separatory Spring 6 8 6 pin Modular Jack: LVC-D10NE/NC pin Modular Jack: LVC-D100NM/NP
Construction Rear View Base Pin RJ Fixing Hole Description 11(6 pin): LVC-D10NE/NC RJ 45 (8 pin): LVC-D100NM/NP 1 NC 1 NC 2 VIDEO OUT 2 VIDEO OUT 3 GND 3 GND 4N C 4N C 5 NC 5 NC 6 12V DC 6 12V DC 7N C 8N C 7
Installation Camera Installation 1. Aim the LG logo of the Dome Camera to face the you wish to watch. 2. Tighten the M4 Tapping Screws to fix the Dome Camera on the ceiling, then adjust the Pan (Left / Right) by moving the Pan Base. Tighten the M4 Tapping Screws after adjustment. Loosen the Tilting Lock Screw. Adjust the Tilt (Up / Down) by moving the Tilt Base then tighten Tilting Lock Screw. Loosen the Focus Lock Screw. Adjust the Focus by moving the Focus Lens then tighten Focus Lock Screw.
Installation NOTE ? When you disassemble the Dome Cover, lift the Dome Cover Separatory Spring on the opposite side of LG Logo and turn the Dome Cover clockwise simultaneously. Dome Cover Separatory Spring ? ? When you install the camera, handle with care. The camera could be damaged by improper handling or storage. If this camera is mounted on the other places except ceiling, you need an extra bracket for mounting.
Check the following guide for the before contacting service. ? The ? Contrast of the possible cause of a problem is poor Does the Dome Cover have lots of dust on the surface? Use a dry cloth to clean the camera when it is dirty. Smear may be caused to the screen of night than daytime. Adjust the Focus by moving the Focus Lens. picture screen is not clear. Check the condition of the monitor. Alight source such as a spot light causes burn-in on the display screen.
90 2.75 inch 0.
Specifications (1) Model LVC-D10NE EIA CCIR 270K/250K 320K/290K Signal System Total / Effective Pixels 1/3-Inch B/W CCD Pick-Up Device Lens (Super HAD) Fixed Lens (f=3.7mm/F=2.0) Gamma 0.45 2 Scanning System : 59.94 Scanning Frequency Resolution Hz(VD) More than 48dB Standard Illuminance 2000Lux 0.2 Lux Sensitivity Output Signal (H) (AGC Off) (3200 K) (50 IRE, F2.
Specifications (2) Model LVC-D100NM NTSC PAL 270K/250K 320K/290K Signal System Total / Effective Pixels Pick-Up Device LVC-D100NP 1/3-Inch Interline Color CCD (Super HAD) Fixed Lens (f=3.7mm/F=2.0) Lens Angular Field of View(D) 92 Focus Manual Signal Process Scanning System Sync. System Scanning Frequency Digital Signal Process 2 : 1 Interlace Internal 59.94 Resolution 330 Hz(VD) Line (H) S/N Ratio More than 48dB Standard Illuminance 2000Lux (3200 K) 1.5 Lux (50 IRE, F2.
P/NO: 3834RS0072T
