Owner's Manual

16
MENU 2
MOTION DET
CAMERA ID
WIDE BURST
INITIAL SET
ON
ON
ON
OFF
MOTION DETECT
SENSITIVIY
MASK AREA SET
RETURN
MOVE POSITION ,
,
CHANGE DATA
• Editing the Camera Setup Menu 2
1. MOTION DETECTION Setting
- Use the
/
button to move the cursor to “MOTION DET”.
- Use the
/
button to set the mode On or Off.
If the MOTION DET is set, “Motion Detected” appears on the
top of monitor.
* Set the SENSITIVITY
- Press the button to move to submenu.
- Use the
/
button to move the cursor to “SENSITIVITY”.
- Use the
/
button to adjust the sensitivity of motion detection.
* Set the area of Motion Detection
- Press the button to move submenu.
- Use the
/
button to move the cursor to “MASK AREA SET”.
- Use the
/
button to move to mask position
- Use the
/
button to set the mask use or not.
* White Mask indicates exception of motion detection.
There are five mask area in this camera.
Notes :
Motion Detection is malfunction under the following situation.
Please note the conditions in the below.
* When shooting an object under flickering fluorescent light.
* When leaves or curtains are swayed by the wind.