Use and Care Guide

- 3 -
ENGLISH
SAFETYPart 1
IMPORTANT NOTE
This installation must be completed by a qualified installer or technician.
• Please read the entire Installation Instructions prior to installation.
• Remove all packing materials from the oven compartments before connecting the electrical supply to the oven.
• Installer: please retain these instructions for local inspector’s reference, then leave them with the consumer.
• Consumer: please read and keep these instructions for future reference and be sure to read the entire
OWNER’S MANUAL prior to use.
• Do not use the parts except for provided components when you install the product.
IMPORTANT NOTE
Proper installation is the responsibility of the installer
and product failure due to improper installation is
NOT covered under warranty.
REQUIRED TOOLS
MATERIALS INCLUDED
(For Model : LWS3081ST, LWD3081ST, LWS3010ST,
LWD3010ST)
MATERIALS NEEDED
Phillips Screwdriver
Junction Box
30’ (76.2 cm)
Metal Bottom Trim
Wire Nuts
36” (91 cm)
of String
3/4” Conduit
Connector
Drill
4X14
6 Wood Screws
For Mounting
(4 needed for installation
and 2 extra’s)
4X8
6 Screws For
Bottom Trim
(3 needed for installation
and 3 extra’s)
MATERIALS INCLUDED
(For Model : LWS3063ST, LWD3063ST, LSWS306ST,
LSWD306ST, LWS3063BD, LWD3063BD, LSWS309BD,
LSWD309BD)
4X14
6 Wood Screws
For Mounting
(4 needed for installation and 2 extra’s)
• The information in this manual
should be followed exactly.
- Failure to do so could result in fire or electrical shock,
causing property damage, personal injury or death.
WARNING
• DO NOT put any weight on the oven
door. Never allow anyone to climb,
sit, stand or hang on the oven door.
- The oven could tip and injury might result from
contact with hot food or the oven itself.
WARNING
• The electrical power must be shut off
while the electrical connections are
being made.
- Failure to do so can result in severe personal injury,
death or electrical shock.
WARNING