Measurement Guide

LWS3063*
QUICK INSTALL &
CLEARANCES
For full installation directions/clearances
please refer to the corresponding
User Manual and Installation Guide.
DIMENSIONS & WEIGHT
Product 29-3/4"(W) x 29-5/16"(H) x 24-3/8"(D)
Cut-out 28-1/2"(W) x 29"(H) x 23-1/2"(D)
Packing 33"(W) x 30"(D) x 34"(H)
Net weight (Kg) Approx. 71.2 kg (157lbs)
Gross weight(Kg) Approx. 81.2 kg (179lbs)
POWER/RATINGS
Rating 4.1 KW
Electric supply 120/240 VAC,120/208 VAC
Max. Amp Load 17.3 A
The rst step of the installation
is measure the current cutout
dimensions and compare them
to the cutout dimensions
shown below. Little or no
cabinet work may be necessary.
IMPORTANT NOTES
•
The cabinet base platform must be able to support 190lbs
(86kg). If the cabinet does not have a solid bottom, two braces
or runners must be installed level with the bottom of the cutout
to support the weight of the oven. Make sure the base is level
and the front of the cabinet is square. If the cabinet base is not
level, the oven glides will tend to slide out when opening the
door.
•
If marks, blemishes or the cutout opening are visible above the
installed oven, it may be necessary to add wood shims under the
runners and front trim until the marks or opening are covered.
•
If the cabinet does not have a front frame and the sides are less
than 3/4” (1.9 cm) thick, shim both sides equally to establish
the cutout width.
•
The junction box must be ush with the rear wall of the cabinet
as shown below.
•
Allow at least a 23” clearance for the door depth when it is
open.
•
Kitchen cabinets in contact with the oven must be heat
resistant up to 194°F (90°C), and fronts of nearby units up to
at least 158°F (70°C).
PRODUCT DIMENSIONS
27 3/8”
(69.5 cm)
29 5/16”
(74.5 cm)
29 3/4”
(75.5 cm)
23 3/8”
(59.3 cm)
28 7/8”
(73.3 cm)
Junction Box
Location
23 1/2”
30”
23”
5”
28 1/2” Min.
28 5/8” Max.
23 1/2”
28 15/16” Min.
29” Max.
Minimum cutout
location from
floor 31”
Allow 1”
minimum for
overlap of oven
Allow 1”
minimum for
overlap of oven
CUTOUT DIMENSIONS
•
Cabinet Width
30” (762 mm)
•
Recommended Minimum
Cutout Location from Floor
31” (787.4 mm)
•
Cutout Depth
23-1/2” Min. (596.9 mm)
•
Cutout Width
28-1/2” Min. (723.9 mm)
28-5/8” Max. (727 mm)
•
Cutout Height
28 15/16” Min. (735 mm)
29” Max. (736.6 mm)
27 3/8”
(69.5 cm)
29 5/16”
(74.5 cm)
29 3/4”
(75.5 cm)
23 3/8”
(59.3 cm)
28 7/8”
(73.3 cm)
Junction Box
Location
23 1/2”
30”
23”
5”
28 1/2” Min.
28 5/8” Max.
23 1/2”
28 15/16” Min.
29” Max.
Minimum cutout
location from
floor 31”
Allow 1”
minimum for
overlap of oven
Allow 1”
minimum for
overlap of oven
LG Brand_Wall Ovens Fin_1.indd 4 8/21/17 4:08 PM