Owner's Manual

8
1
Press CLOCK.
(If
the clock
requires
setting,
press
and hold
CLOCK for more than
2
seconds.)
-
The hours
begin
to flash.
2
Select
a 12
hour
cycle
or
24
hour
cycle by
pressing
TUNING
()
on the front
panel.
3
Press SET to confirm the selected hour
cycle.
4
Use TUNING
()
buttons to set the
correct hours on the front
panel.
5
Press SET.
6
Use TUNING
()
buttons to set the
correct minutes on the front
panel.
7
Press SET
and
the correct time is shown on
the
display.
8
Press CLOCK
at
any
time to
display
the time
for about 3 seconds.
ote
The
unit
can also set the clock function
in
power
off
state.
(12HR) (24HR)
or
Sleep
Function
When the
sleep
timer is
used,
the
power
is
automatically
turned off after the
specified
time has
elapsed.
1
To
specify
the time
delay
before the
power
is
turned
off,
press
SLEEP.
In
the
display
window
you
can see
for about 5 seconds. This means that the
system
turns off
automatically
after 90 minutes.
Each time the button is
pressed
the time interval
before
it
turns off is reduced
by
10 minutes. i.e.
80...70... etc.
Select the desired time to
turn
off.
2
To check the
remaining
time
until
the
power
is
turned off.
While the
sleep
function is active
press
SLEEP
briefly.
The time
remaining
until it
turns off is
displayed
for about 5 seconds.
ote
If
you press
SLEEP while the
sleep
time is
displayed,
the SLEEP time is reset.
To cancel the
sleep
timer mode
If
you
wish to
stop
the
function,
press
the SLEEP button
repeatedly
until
"SLEEP 10"
appears,
and then
press
SLEEP once
again
while "SLEEP 10" is
displayed.
Setting
the CLOCK
Auxiliary
Function
1
Connect an
auxiliary
device i.e.
TV
or
VCR,
via the rear mounted AUX
phone
sockets.
2
Press AUX.
ote
You can also record from the
auxiliary input
source,
see
Recording
Section.