Owner's Manual

PREPARATION
11
Before Operation
Setting the Clock
11
Press CLOCK.
(If the clock requires setting, press and hold CLOCK
for more than 2 seconds.)
- The hours display begins to blink.
22
Select either the 12 hour cycle or the 24 hour
cycle by turning MULTI JOG.
33
Press SET/CD
[[
to confirm the selected hour
cycle.
44
Use MULTI JOG to set the current hour.
55
Press SET/CD
[[
.
66
. Use MULTI JOG to set current minutes.
77
Press SET/CD
[[
and the correct time is shown in
the display window.
Sleep Timer Function
When the sleep timer is set, the unit automatically turns
off after the specified time has elapsed.
11
To specify the time delay before the power is
turned off, press SLEEP.
In the display window you can see SLEEP 180 for
about 5 seconds. This means that the system turns
off automatically after 180 minutes.
22
Each time you press SLEEP the setting changes
in the following order.
SLEEP 180 →150 → 120 →90→80→70 → 60→ 50 →
40 → 30 → 20 →10 → OFF (No display) →SLEEP 180...
33
To check the remaining time until the power is
turned off.
While the sleep function is active press SLEEP
briefly. The time remaining until the unit turns off is
displayed for about 5 seconds.
Note
Note
If you press SLEEP while the sleep time is displayed,
the SLEEP time is reset.
To cancel Sleep Timer setting
If you wish to stop the function, press the SLEEP button
repeatedly until “SLEEP 10 ” appears, and then press
SLEEP once again after “SLEEP 10 ” shows on the
display.
Using Microphone (OPTIONAL)
You can sing to a music source by connecting a
microphone to the unit.
11
Connect your microphone to the MIC1/ MIC 2
Jacks.
“ ” will be shown in the display window.
22
Play the music you want.
33
Sing along with the accompaniment.
Adjust the microphone volume by turning MIC VOL.
volume knob. (MIN,1 - 14, MAX steps)
Notes
Notes
• When not using the microphone, set the MIC VOL.
volume knob to minimum or turn off the MICs and
remove the microphone from the MIC Jacks.
• If the microphone is set too near the speaker, a howl-
ing sound may be produced. In this case, move the
microphone away from the speaker or decrease the
sound level by using the MIC VOL. volume control.
• If sound through the microphone is extremely loud, it
may be distorted. In this case, turn the MIC VOL. vol-
ume control toward minimum.
To Adjust ECHO Volume
You can give an echo effect to the sound from the
microphones.
Press ECHO VOL. ( / ) on the remote control to
increase the echo volume or decrease it.
(MIN,1 - 14, MAX steps)
DIMMER
This function dims the LED (Light-emitting diode) of
front panel by half in power-on status.
Press DIMMER once. The LED (Light-emitting diode) of
front panel is turned off and the display window will be
darken by half.To cancel it, press DIMMER again.
DEMO
Press PLAY MODE in power off state to demonstrate
the function in the display window.
To cancel it , press POWER ( / I) or PLAY MODE again.
(12HR)
(24HR)
or