Owner's Manual

Before Operation

DISPLAY

TV Aspect

4:3 – Select when a standard 4:3 TV is connected.

16:9 – Select when a 16:9 wide TV is connected.

Display Mode

The display Mode setting works only when the TV

Aspect mode is set to “4:3”.

Letterbox – Displays a wide picture with bands on the

upper and lower portions of the screen.

Panscan – Automatically displays the wide picture on

the entire screen and cuts off the portions that do not fit.

Progressive Scan

Progressive Scan Video provides the highest quality pic-

tures with less flickering.

When you are using the COMPONENT VIDEO OUT

jacks, but are connecting the unit to a standard (analog)

television, set Progressive Scan to Off.

If you are using the Component Video jacks for

connection to a TV or monitor that is compatible with a

progressive scan signal, set Progressive Scan to On.

To Turn ON progressive scan:

Connect component out of the unit to the input of your

monitor/television, set your television or monitor to

Component Input.

1 Select “Progressive Scan” on the DISPLAY menu

then press .

2. Select “On” using the / buttons.

3. Pressing SELECT/ENTER will set the player to

Progressive scan mode.

Caution

Once the setting for progressive scan output is entered,

an image will only be visible on a progressive scan

compatible TV or monitor. If you set Progressive Scan

to on in error, you must reset the unit. First, remove the

disc in the unit. Next, press STOP( x ) on the remote

control and hold it for five seconds before releasing it.

The video output will be restored to the standard set-

ting, and a picture will once again be visible on a con-

ventional analog TV or monitor.