Owner's Manual

16
1 Select Start > Control Panel > Hardware and Sound > Sound.
2
Click the Play tap rst. Right-click on the DP device or speakers you want and select Set as
Default Device then click OK to connect the audio device or select Disable to disconnect it.
※ In order to change the audio devices, you may restart the computer.
Connecting/Disconnecting DP(DisplayPort) Audio Device in Windows Embedded Standard 7P
Attention
● If an audio device is connected or removed while media content is played, you need to stop the content
and play again.
● If an DP cable is removed from the MP700, sound does not play. In addition, when the cable is
reconnected, it may take time before sound plays again.
1
Connect the RS-232C Out port of the MP700 to the RS-232C In port of the rst monitor (SET ID 1).
2
Connect rest of the monitors using a RS-232C cable. (Be careful about input and output ports.)
MP700
RS232C Cable
( SET ID Max )
MP700
RS232C Cable
( SET ID Max )