Owner’s Manual

11
1 Connect the appropriate power cables to a monitor and NC1000 respectively.
Connecting a Monitor with D-sub Cable
In/Out Cable Connection
In order to watch video on a monitor, you need to use a D-sub cable or an HDMI cable to connect the
NC1000 to a monitor.
Attention
 D-sub, HDMI, LINE-OUT, OPTICAL, and LAN cables are not included with the NC1000. If the cables were
not provided with your monitor, you may need to purchase them separately.
 After cabling is complete, assign the SET ID of the monitor to be connected to NC1000.

Attention

or OPTICAL cable.
When using the SuperSign Manager software:
 The monitor SET ID is a unique number used to identify the monitor. You can choose a number from 1 to 25.
The SET ID allows the SuperSign Manager software to identify the monitor.
In order to directly connect the monitor to NC1000, its SET ID must be set to 1.
 To use SuperSign Manager, the monitor that will be connected to NC1000 must support the LG RS232C pro-
tocol. A monitor supporting the LG RS232C protocol can control the monitor functions, such as brightness
and sound, using SuperSign Manager.
Note
● D-sub cables are also known as RGB cables.
Note