Owner’s Manual

Table Of Contents

Connect the appropriate power cables to a monitor and NC1100/NA1000/NA1100 respectively.

Connecting a Monitor with D-sub Cable

In/Out Cable Connection

To view images on the monitor, you need to connect NC1100/NA1000/NA1100 to the monitor via a D-SUB,

HDMI or DP cable.

Attention

 D-SUB, HDMI, DP, LINE-OUT, MIC-IN and LAN cables are not included in the basic components. If the

cables were not provided with your monitor, you may need to purchase them separately.

 After cabling is complete, assign the SET ID of the monitor to be connected to NA1000/NC1100/NA1100.



Attention

Audio is not available when only the D-SUB cable is connected to the monitor. A LINE-OUT cable must be

connected for audio output to function.

When using the SuperSign Manager software:

 The monitor SET ID is a unique number used to identify the monitor. You can choose a number from 1 to 25.

The SET ID allows the SuperSign Manager software to identify the monitor.

In order to directly connect the monitor to NC1100/NA1000/NA1100, its SET ID must be set to 1.

 To use SuperSign Manager, the monitor that will be connected to NC1100/NA1000/NA1100 must support the

LG RS232C protocol. A monitor supporting the LG RS232C protocol can control the monitor functions, such

as brightness and sound, using SuperSign Manager.

Note

D-sub cables are also known as RGB cables.

Note

MIC IN