Owner's Manual

Troubleshooting
23
2. If you change the location of the speaker that is in use,
2-1. If the changed location is too far from the home router,
it may not be connected. Place and use it at a location
that is close enough to router.
2-2. Connect the speaker with a LAN cable, and for
additionally installed speakers, if they are not close
enough to the speaker connected with a LAN cable,
additionally install Bridge or another speaker in the
middle location between the speaker connected
with LAN cable and the speaker with sound being
disconnected.
There are times that speaker disappears from the
application
1. If the speaker blinking lamp is not blinking, and stays as
white: Even after the speaker power off and on, if the problem
continues, in this case you have to reset the speaker (To reset,
press and hold the (ADD) button for 8 seconds until you
hear one beep.) and need to register again. Carry out speaker
installation or additional procedures.
2. If the speaker blinking lamp blinks white - network signal is
unstable. Wait for a while, or move the speaker to another
location closer to other speaker or router.
3. Press menu key or menu at the top right side of Home screen
to end Music Flow Player app and run again.
Music sound breaks and unstable MUSICflow
system
1. If speaker with breaking sound is connected through wireless
connection mode,
y
If the distance between speaker and home router is not
close enough, the corresponding condition may occur.
Move speaker closer to home router and try again.
y
If the device with sound source to play (Ex. phone or
NP8350-M0.BSGPLLK_SIM_ENG_MFL68922605.indd 23 2015-03-20  5:26:36