_index ENGLISH OWNER’S MANUAL Safety and Reference Please read this manual carefully before operating your set and retain it for future reference. *MFL71751703* (2106-REV03) www.lg.com Copyright © 2021 LG Electronics Inc. All Rights Reserved.
Title Warning! Safety instructions Connections Preparing Troubleshooting -- Lifting and moving the TV -- Mounting on the Table -- Mounting to the Wall -- Antenna/Cable -- Satellite dish Specifications -- Open Source Software Notice Information -- Licenses Precautions for Protecting the OLED TV Screen Starting TV -- Turning on the TV -- Registering Magic Remote Control -- Connecting Smart Devices using NFC Tagging Using Remote Control -- Using Magic Remote Control Before read
Warning! Safety instructions CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
•• Disconnecting the Device from the Main Power -- The power plug is the disconnecting device. In case of an emergency, the power plug must remain readily accessible. •• Do not let your children climb or cling onto the TV. Otherwise, the TV may fall over, which may cause serious injury. •• Outdoor Antenna Grounding (Can differ by country): -- If an outdoor antenna is installed, follow the precautions below.
•• Batteries -- Store the accessories (battery, etc.) in a safe location out of the reach of children. -- Do not short circuit, disassemble, or allow the batteries to overheat. Do not dispose of batteries in a fire. Batteries should not be exposed to excessive heat. -- Caution: Risk of fire or explosion if the battery is replaced by an incorrect type. •• Moving -- When moving, make sure the product is turned off, unplugged, and all cables have been removed. It may take 2 or more people to carry larger TVs.
Preparing Lifting and moving the TV Please note the following advice to prevent the TV from being scratched or damaged and for safe transportation regardless of its type and size. •• It is recommended to move the TV in the box or packing material that the TV originally came in. •• Before moving or lifting the TV, disconnect the power cord and all cables. •• When holding the TV, the screen should face away from you to avoid damage. •• Hold the side and bottom of the TV frame firmly.
Mounting on the Table 1 Lift and tilt the TV into its upright position on a table. • Leave a 10 cm (minimum) space from the wall for proper ventilation. 2 Connect the power cord to a wall outlet. 10 cm 10 cm 10 cm (Depending on model) •• Do not apply foreign substances (oils, lubricants, etc.) to the screw parts when assembling the product. (Doing so may damage the product.) •• If you install the TV on a stand, you need to take actions to prevent the product from overturning.
Mounting to the Wall Attach an optional wall mount bracket at the rear of the TV carefully and install the wall mount bracket on a solid wall perpendicular to the floor. When you attach the TV to other building materials, please contact qualified personnel. LG recommends that wall mounting be performed by a qualified professional installer. We recommend the use of LG’s wall mount bracket. LG’s wall mount bracket is easy to move with cables connected.
Wall Mounting Bracket (Depending on model) Make sure to use screws and wall mount bracket that meet the VESA standard. Standard dimensions for the wall mount kits are described in the following table.
Starting TV Turning on the TV You can simply operate the TV functions, using the button. Using button Power On (Press) Power Off1) (Press and Hold) Menu Control (Press2)) Menu Selection (Press and Hold3)) 1) All running apps will close, and any recording in progress will stop. (Depending on country) 2) You can access and adjust the menu by pressing the button when TV is on. 3) You can use the function when you access menu control.
Adjusting the menu When the TV is turned on, press the button one time. You can adjust the Menu items using the button. Turns the power off. Changes the input source. Adjusts the volume level. Scrolls through the saved programmes. Note Turns the power off. Accesses the settings menu. Clears on-screen displays and returns to TV viewing. Changes the input source. •• Your TV’s OSD (On Screen Display) may differ slightly from that shown in this manual.
Registering Magic Remote Control How to register the Magic Remote Control To use the Magic Remote, first pair it with your TV. 1 Put batteries into the Magic Remote and turn the TV on. 2 Point the Magic Remote at your TV and press the Wheel (OK) on the remote control. * If the TV fails to register the Magic Remote, try again after turning the TV off and back on. How to deregister the Magic Remote Control (Back) and Press the * Press and hold the same time.
Using Remote Control Using Magic Remote Control (Depending on model) The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly. Power Turns the TV on or off. Accesses the saved programmes list. Number buttons Enters numbers. Accesses the [Quick Help]. Microphone Accesses the [Guide]. Accesses the [Edit Quick Access].
Connections Connect various external devices to the TV and switch input modes to select an external device. For more information of external device’s connection, refer to the manual provided with each device. HDMI •• When connecting the HDMI cable, the product and external devices should be turned off and unplugged. •• Supported HDMI Audio format (Depending on model): True HD (48 kHz), Dolby Digital / Dolby Digital Plus (32 kHz, 44.1 kHz, 48 kHz), PCM (32 kHz, 44.
USB Some USB Hubs may not work. If a USB device connected using a USB Hub is not detected, connect it to the USB port on the TV directly. Note •• For an optimal connection, HDMI cables and USB devices should have bezels less than 10 mm thick and 18 mm width. Use an extension cable that supports if the USB cable or USB memory stick does not fit into your TV’s USB port. B B A CI module Note A * A< = 10 mm * B< = 18 mm View the encrypted (pay) services in digital TV mode.
External Devices Note 16 Available external devices are: Blu-ray player, HD receivers, DVD players, VCRs, audio systems, USB storage devices, PC, gaming devices, and other external devices. •• The external device connection may differ from the model. •• Connect external devices to the TV regardless of the order of the TV port. •• If you record a TV program on a Blu-ray/DVD recorder or VCR, make sure to connect the TV signal input cable to the TV through a DVD recorder or VCR.
Troubleshooting Cannot control the TV with the remote control. •• Check the remote control sensor on the product and try again. •• Check if there is any obstacle between the product and the remote control. •• Check if the batteries are still working and properly installed ( to , to ). No image display and no sound is produced. •• Check if the product is turned on. •• Check if the power cord is connected to a wall outlet. •• Check if there is a problem in the wall outlet by connecting other products.
Specifications (Depending on country) Broadcasting Specifications Television system DVB-S/S21) Channel coverage (Band) Maximum number of storable programmes 950~2,150 MHz Analogue TV DVB-S/S2 DVB-T/T2 DVB-C PAL B/B, PAL B/G, PAL D/K, PAL-I, SECAM B/G, SECAM D/K, NTSC-M DVB-C1) DVB-T/T21) 46 ~ 890 MHz VHF III : 174 ~ 230 MHz UHF IV : 470 ~ 606 MHz UHF V : 606 ~ 862 MHz S Band II : 230 ~ 300 MHz S Band III : 300 ~ 470 MHz 6,000 3,000 External antenna impedance 75 Ω CI Module (W x H x D) 10
Wireless module(LGSBWAC95)Specifications Wireless LAN (IEEE 802.11a/b/g/n/ac) Frequency range Output Power (Max.) 2,400 to 2,483.5 MHz 19 dBm 5,150 to 5,725 MHz 18 dBm 5,725 to 5,850 MHz 13.5 dBm Bluetooth Frequency range Output power(Max.) 2,400 to 2,483.5 MHz 9 dBm As band channels can vary per country, the user cannot change or adjust the operating frequency. This product is configured for the regional frequency table.
Open Source Software Notice Information To obtain the source code under GPL, LGPL, MPL, and other open source licenses, that is contained in this product, please visit https://opensource.lge. com. In addition to the source code, all referred license terms, warranty disclaimers and copyright notices are available for download.
Precautions for Protecting the OLED TV Screen Unlike regular LED/LCDs, OLED TVs produce images that emit light for each pixel, achieving a perfect black colour and delivering clear images without blurring. Due to the nature of the organic materials used to achieve high-resolution image quality, OLED displays generally experience image retention on the screen, which can be a persistent phenomenon.
Recommendations for Minimising Image Retention When watching the TV for a long time, press the button on the remote control, go to → [Picture] → [Select Mode] and set the mode to [Eco], go to [Advanced Settings] → [Brightness] and set [OLED Pixel Brightness] to a lower level. In addition, press the button on the remote control, go to → [Support] → [OLED Screen Saver] and set the [Adjust Logo Brightness] value to [High].
The model and serial number of the product are located on the back and on one side of the product. Record them below in case you ever need service. Model Serial No.
