Owner's Manual

33
EXTERNAL EQUIPMENT CONTROL SETTING
ENGLISH
32
ADDITIONAL OPERATION –VENTILATION
EXTERNAL EQUIPMENT CONTROL SETTING
External equipment control
It is the function to set the contact point output of the external equipment control mode.
• In the main screen, press [<,>(left/right)] button to select the external equipment control cate-
gory, and press [∧,∨(up/down)] button to set the contact point output.
Mode Description
On When it is set to “On”, it always performs the contact point output.
Off
When you set it to “Off”, it does not perform the contact point output in
any case.
Auto
When it is set to “auto”, the contact point output is decided according to
the user setting’s external equipment logic setting value.
NOTE
!
Please use the corresponding function when the external equipment is actually connected.
When the external equipment is not set, please maintain “Off” status.
For the detail external equipment control condition setting, refer to the user setting - external
equipment logic setting.
ADDITIONAL OPERATION –VENTILATION
Additional operation
You can change the additional operation of the ventilation product.
• In the main screen, press [<,>(left/right)] button to select the additional operation category, and
press [∧,∨(up/down)] button to set the additional operation.
Additional Operation Description
Fast
It ventilates in short period of time.
It is the function to operate the ventilation function more efficiently
through the express setting which is an additional operation of the ventila-
tion product.
Energy saving It performs the energy saving function while ventilating efficiently.
NOTE
!
The general ventilation and the direct cooling type ventilation’s additional operation are the
same.
The ventilation product’s additional functions (air cleaning / heater / humidification / fan auto)
setting methods are the same as the air conditioner.