Owner's Manual

115

INSTALLATION

114

SERVICE SETTING

ENGLISH

Open source license

View the remote controller’s open source license.

• In the service setting list, select the open source license category, and press [OK] button to

move to the detail screen.

INSTALLATION

Installation of Remote Controller

• After fixing the remote controller installation plate on the desired location, fix it firmly with the

provided screws.

- If the installation plate is not flat on the surface, it may result in the controller being twisted

and cause a defect.

- If there is a mounting box, install the remote controller installation plate using the fixings holes

which suit, as in the below diagrams.

- Do not leave a gap with the wall or product loose after the installation.

• The wired remote controller cable can be installed in 3 directions. Install to the suitable

direction according to the installation environment.

- Installation direction: Rear entry, top side, right side

- When you install the remote controller cable at the top side and right side, remove the remote

controller cable guide hole before the installation.

※ Use a long nose pliers to remove the guide hole.

• After removing the hole, trim the cut surface neatly.

• After fixing the remote controller top side on the installation plate attached to the wall as in the

following figure, press the bottom side to combine with the installation plate.

- Do not leave a gap in the top, bottom, left, and right side of the remote controller and the in-

stallation plate after combining them.

- Before combining with the installation plate, arrange the cables to avoid interference with the

circuit parts.

ڹ Top side guide groove

ڸRear cable entry

ںRight side guide

groove

ںRight side guide

groove

Wall Wall