Install Instructions

9
Installation Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
CONTROLLER INSTALLATION
Selecting Installation Location
The room temperature sensor is inside the controller, so the installation
location is critical to proper system operation. Install the controller in a
location away from direct sunlight, high humidity, and direct flow of hot or
cold air. Install the controller on a flat, clean wall surface approximately 5 ft
above the floor in an area with good circulation and average temperature.
Do not install the controller where it is exposed to:
• Drafts or dead spots behind doors and in corners
• Hot or cold air from ducts
• Radiant heat from sun or appliances
• Concealed pipes or chimneys
• Uncontrolled areas such as on an outside wall
Refer to Figure 1 for a typical installation location.
Figure 1: Typical Controller Location
5ft
no
no
yes
09-26-2017
2:43 PM
Occ Auto Heat
74°
78
Indoor °F
Humidity
66 %
68
Auto
Locked by central controller
09-26-2017
2:43 PM
Occ Auto Heat
74°
78
Indoor °F
Humidity
66 %
68
Auto
Locked by central controller
no