Install Instructions

Installation Manual

Due to our policy of continuous product innovation, some specifications may change without notification.

ZigBee Pro and Wi-Fi Wire-

less Modules

Follow this procedure to install the optional

wireless modules (models ZVRCZPWC2 and

VCM8002V504). The Zigbee* Pro wireless

module is required for the controller to com-

municate with the optional wireless sensors

and the Wi-Fi module is required for BACnet

over IP.

ACCESSORIES INSTALLATION

Figure 8: ZigBee Pro and Wi-Fi

Wireless Modules

1. Remove security screw (if any) on

bottom of Remote Controller cover.

2. Open unit by pulling on bottom side

of Remote Controller (Figure 9).

3. Carefully remove Remote Control-

ler’s Motherboard from casing and

turn over.

4. Locate gap in upper-right corner of

Remote Controller’s motherboard

and locate holes to insert the module

into the motherboard (Figure 10).

5. Align connector pins on Zigbee

Pro or Wi-Fi module with holes on

motherboard. Ensure alignment of

pins is correct so as to not damage

the module.

Figure 9: Open Cover

*ZigBee is a registered trademark of the ZigBee Alliance.