Manualshelf

Install Instructions

ManualsBrandsLG ManualsAccessoriesCRC2 Plus MultiSite Remote Controller
31323334353637383940
37
Installation Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
ACCESSORIES INSTALLATION
Water Leak Sensor Operation
Pairing with a controller
1. Refer to the remote controller user guide to put the remote controller into pairing
mode.
2. Short press the function key 3 times within 1 second.
3. The sensor pairs with the controller.
Resetting the sensor
1. Short press the function key 3 times within 1 second.
2. Press and hold the function key until the status LED indicates factory reset mode
(approximately 10 seconds):
3. Release the function key.
4. The sensor restarts.
Checking the sensor status
1. Short press the function key 3 times within 1 second.
2. Check the status displayed on the LED indicator:
• If blinking yellow, sensor is not connected (looking for a controller).
• If blinking green, sensor is connected to a controller.