Install Instructions

MultiSITE CRC 2 Controller

Due to our policy of continuous product innovation, some specifications may change without notification.

ZigBee Pro Quick Setup

This quick set-up describes how to pair a ZigBee sensor with

a Remote Controller. Please see ZigBee Configuration section

of the MultiSITE CRC2 User Interface Guide (Network Config/

Zigbee settings via the CRC menu) if this is the first time a

sensor is being paired with the remote controller for proper

configuration of the ZigBee Wireless network.

1. Go to first sensor screen in Zigbee Ecosystem section of

MultiSITE CRC2 Series Remote Controller's interface and

set “Permit join” to On. Permit join is only available on the

first Zone Screen but is applicable to all Zones.

2. Insert battery. Remove pull tab (for contact sensors) or

press button for sensors without pull tab to activate ZigBee

sensor. If sensor does not join ZigBee wireless network

press the button located on the sensor ten (10) times to

reinitialize joining process.

3. Verify sensor has joined network and Paired field status

reads Yes on Zone screen.

4. Use the “Set function to” control in the Zone Screen to

select sensor type (Motion, Window or Door).

5. Set Permit Join on MultiSITE CRC2 Series Remote

Controller to Off when pairing process is complete.

Troubleshooting

MultiSITE CRC2 Series Remote Controller User Interface

Guide is available at www.lghvac.com.

ZIGBEE SETUP