PREMTBVC Owners Manual
12
MultiSITE CRC 2 Controller
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
CONTROLLER OVERVIEW
Adjusting Setpoints in Auto Mode
Cooling/Heating Setpoint change.
current operating cycle, a change in setpoint is now applied to the current mode.
Auto Mode, Cooling Cycle, Cooling Setpoint (Dual Setpoint setting)
When in cooling cycle of Auto Mode, use the up and down arrows to raise or lower the cooling setpoint.
When the setpoint is modified it will increase or decrease the difference between the cooling and heat-
ing setpoint values. The minimum difference allowed between cooling and heating setpoints is determined
by the Dual Setpoint Deadband control value setting (found in the Installer/Temperature Settings screen).
"Cooling Setpoint" shows as indicated on the screen to the left.
Auto Mode, Cooling Cycle, Heating Setpoint (Dual Setpoint setting)
To change the heating setpoint when in Auto Mode, cooling cycle, tap the up or down arrows to place the
controller into set point configuration mode and then immediately tap the Mode button once to change to
heating set point mode. "Heating Setpoint" shows when this parameter is set. Immediately move back to the
set point up or down arrows to change the heating set point.
Auto Mode, Cooling Cycle, Cooling/Heating Setpoint (Dual Setpoint setting)
To change the cooling and heating setpoints simultaneously, a third option is available for adjusting set-
points. If in Auto Mode (either cooling or heating cycle), tap either the up or down set point buttons, then
immediately tap the Mode button until “Cool/Heat Setpoint” shows, indicating that the controller is in the
correct set point mode. Immediately move back to the up or down set point buttons to change the set points
as desired.
05-16-2021
2:43 PM
Occ Auto Heat
74°
Indoor °F
Humidity
66 %
Auto
78
68