PREMTBVC Owners Manual

27
User Interface Guide
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
CONFIGURATION SCREENS
Setback Setup
Press the Setback Setup button on the Building Manager screen to display the Setback Setup screen. Setback parameters
including set points, system mode, and fan speed are configured on this screen.
Setback Operation
If the controller is in Setback mode and the user changes the Mode, Fan Speed or Set Points, the controller exits Setback
mode and keeps settings as applied by the user until the next scheduled event occurs. Setback mode can also be exited if
the user presses the Setback mode button again from the Operation Mode screen while in Setback mode. The setback icon
on the Operation Mode screen will indicate if that mode is active or not.
Setback
Setpoint cool
Setpoint heat
System mode
Fan speed
74°F
70°F
Auto
Med
Setback enabled
Enabled
Parameter Parameter Settings
Setback enabled When enabled, setback logic will not be triggered during unoc-
cupied status.

Setpoint (Single Setpoint) 

 72°F
Setpoint cool (Dual Setpoint) 52-99 °F
 78°F
Setpoint heat (Dual Setpoint) 40-90 °F
 68°F
System mode 󰀨
 Auto
Fan Speed 
 Medium
Default Parameters are dependent on if the controller is in Single Setpoint Mode or Dual Setpoint Mode.
Building Manager