PREMTBVC Owners Manual

63
User Interface Guide
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
PIR (Motion Sensor)
The MultiSITE CRC2+ and CRC2+Z versions of the controller come with an onboard PIR style motion sensor.
Accessories are also available to enable the CRC2 base model to sense motion. If the sensor is enabled (installer
configuration under Accessories), status from the PIR sensor will be used to control the operation of the IDU as
follows:
If the IDU status is currently Occupied and the onboard PIR goes Unoccupied, the IDU will operate according to
the Setback values of the controller and will change its status to Unoccupied.
If the IDU status is currently Unoccupied and the onboard PIR goes Occupied, the IDU will operate according to
the settings in use during the last Occupied status and will change its status to Occupied.
If the IDU is currently in Setback or Override modes, information from the PIR sensor will be ignored.
CONFIGURATION SCREENS