Manual Here

MOUNTING INSTRUCTIONS:
1) Place the speaker on the wall at the desired mounting location.
2) For Vertical Orientation: Make a small mark on the wall at the bottom center of
the speaker.
For Horizontal Orientation: Make a small mark on the wall at the top center of the
speaker. For the P-WAFR LCR 25 make a mark 1" lower then the top center of
the speaker.
3) Remove the speaker from the wall and place the appropriate wall mount bracket:
For Vertical Orientation: so that the mark on the wall lines up with the bottom
center of the bracket.
For Horizontal Orientation: so that the mark on the wall lines up with the top
center of the bracket.
4) Orient the bracket so that it is level. Mark on the wall the locations for the
bracket’s mounting screws. Remove the mounting bracket from the wall.
5) Drill 2" deep pilot holes at each of the mounting screwhole marks on the wall
using the 1/8" bit if mounting into a stud, or the 1/4" bit (and then inserting the
included wall anchors) where there is no stud.
6) Place the bracket back on the wall lining up the screw holes of the bracket with
the holes on the wall. For vertical installations be sure to orient the bracket with
the large ‘stop’ indentations at the bottom. Screw the included mounting screws
fully into the pilot holes or wall anchors. The bracket should now be securely
attached to the wall.